Basic Technical Parameters

Power Supply: 380V, 50Hz
 2Total power of the two-position equipment is approximately 12.3 kW. Includes 4 kW motors for 2 grinding heads, 4 adjustment motors for the grinding heads (2 for up/down adjustment and 2 for front/back adjustment), each motor rated at 0.37 kW, and a guide wheel motor rated at 0.75 kW.
   1.1 kW exhaust fan motor (1 fan unit).
3Two-position machinery weight: approximately 600 kg.
4Two-position mechanical dimensions: 1230*1550*1350mm
5Feeding speed: adjustable from 1 to 12 meters per minute, controlled by a variable speed motor.
6Polishing Wheel: Speed 2800 RPM. Wheel Diameter 250-300mm, Width 80mm, Bore 32mm
 

1. Precision polishing inspection of the rough polishing stainless steel bright tubes, ensuring that all surfaces are fully smoothed, without scratches, dents, pull marks, deep cuts, and other defects. Additionally, verify that the polishing is uniform with no variations in depth. Meanwhile, guarantee that the rough polishing process can completely achieve the desired surface finish.240 mesh. Then switch to a 320 mesh polishing wheel to start the fine polishing on the stainless steel bright pipes, ensuring the surface is even after polishing, with no noticeable unevenness to the touch, and that the polished surface achieves a roughness of Ra0.8μm. (During the fine polishing process, very fine scratches can be repaired, but for other existing defects, they can only be returned to the previous process. The cost of repairing defects from the previous process in this step is too high.)