Specialized non-standard equipment for manufacturing wave-tooth composite gaskets and metal toothed gaskets..PLCNumerical Control System, hydraulic system. It is specifically designed for the production of wave spring washers and metal toothed washers.V"And"UForm Angle.It is a new production process for manufacturing wave-tooth composite washers and metal tooth washers..In the past, the production of wave-tooth composite gaskets and metal toothed gaskets involved mounting specific fixture clamps on a standard lathe.,And there are many processing procedures.,Labor-intensive,Time-consuming,Waste material,The usage rate of raw materials is low.,Excessive waste at the bottom.Especially in the production of larger diameter wave and metal toothed composite washers,Standard lathes cannot process,A large vertical lathe is required for the machining production.,Highly complex processing.Additional processing fees that further increase production costs.And this equipment,Utilized a new production process,Using standard lathe cutters for production (at a lower cost than using special milling cutters) reduces the cost of manufacturing wave-tooth composite washers and metal tooth washers. The production process is fully automated.

Main Technical Parameters:
Voltage:380V50HZ     Variable speed motor:1.5KW     0~1320Please provide the Chinese content to be translated./Please provide the Chinese content to be translated.
Bore diameter:50mm     Bore travel:100mm     Drive shaft wheel:100mm
Ring thickness:2，3，4，5mm           Scope of Processing:DN300Above