This sensor operates based on the direct measurement Hall effect principle. The magnetic flux generated by the primary current is concentrated in the magnetic circuit, and the Hall voltage signal is detected by the Hall device. After amplification by the amplifier, the voltage signal accurately reflects the primary current.

Product Features:

AC, DC, and pulse signals measurable

Strong resistance to external interference, high common-mode rejection ratio

Low-temperature blooming, fast response time, wide bandwidth

Perforated structure, no insertion loss

Open design structure, easy to install

Application Scope:

Communication Variable Frequency Speed Control

Servo motor traction

Uninterruptible Power Supply (UPS)

Welding machines, battery-powered sources

Technical Specifications:

Dimensions and Installation Size

Circuit linkage diagram

Description:

IPN: Primary Side Current Input Direction

+ : 12/15V Power Supply

- -12/15V Power Supply

M: Secondary Side Signal Output

G: Ground terminal

OFS: Zero-point adjustment

GIN: Amplitude Adjustment

Installation Precautions

Sensors must be properly wired; otherwise, internal components may be damaged.

The dynamic performance (di/dt and response time) is good when the input current is fully filled in the primary side穿孔.