Tangxia factory building wall renovation, electrical and water installation design and construction, the major project is to create partitions. This is a primary aspect that distinguishes office renovation from residential renovation, with common partition walls being made of stainless steel, glass, and iron.

1. Stainless steel partition wall

Tangxia Factory Wall Renovation - A type of stainless steel partition with glass installed on the frame. The outer shell of the partition frame is made of stainless steel plate, with a foam plastic core inside, which can contain fibers. The cross-section of the partition frame is in an I-beam or rectangular shape. The glass between partition frames is embedded in strips of hard polymer plastic inserts. The outer surface of the hard polymer plastic inserts is covered with stainless steel covers, which are inserted into the slots of the inserts. The outer shell of the partition frame can be fitted with a connecting liner, which is cavity-shaped, grid-shaped, or honeycomb-shaped. This practical partition not only has an elegant decorative appearance but also serves as a structural support. The frame and glass are securely sealed between the hard polymer plastic inserts, ensuring good stability, safety, and strength. Assembly is simple, and replacement is convenient. It is lightweight, high-strength, sound-insulating, heat-insulating, and has excellent sealing properties. It can withstand wind pressure, impact resistance, and shock absorption.

2. Gypsum board partitions

Tangxia Factory Wall Renovation: If the horizontal joints of the gypsum board are not on the edge steel, additional cross steel should be added to secure the panel. When installing equipment such as electrical distribution boxes, outlets, and wall pipes in partition walls, the gaps around them should be sealed. The types, standards, and quality of materials used in construction must meet the requirements of the construction and design units as well as the construction quality standards. Check all pipeline positions related to the walls before starting work. It is necessary to mark the wall and door opening positions before construction, ensuring that the door jambs are securely connected to the floor.