· Application Principle:
Metallic perforated plate corrugated packing is made by punching holes in metal thin plates, rolling fine grooves, pressing the corrugations, and then assembling them. It features low resistance, uniform gas-liquid distribution, high efficiency, large flow rate, and insignificant amplification effect, and is applicable to vacuum, atmospheric, and pressurized operations. The transformation of plate towers with metallic perforated plate corrugated material is particularly effective.
metal perforated plate corrugated packing is formed by perforating the surface of the metal sheet, rolling small lines, and pressing and corrugating. It has the characteristics of uniform resistance, small gas-liquid distribution, high efficiency, large flux, and no obvious effect, and application for Negative pressure, normal pressure and pressurized operation. The effect of transforming the plate tower with metal orifice corrugated packing is particularly obvious.
· Technical Specifications
| Model Type | Peak Height Wave height mm | Inclination Inclined angle | Sheet material area Theory sheet area | Specific Surface Area Surfacearea ㎡/m3 | Porosity %)Void | Pressure Reduction Pressure drop MPa/m | Heavily piled Density Kg/m3 | Highest F Factor F factor m/s(Kg/m3)0.5 | Liquid Load Liquid load |
| 125Y | 24 | 45° | 1-1.2 | 125 | 98.5 | 2*10(-4) | 85-100 | 3 | 0.2-100 |
| 250Y | 12 | 45° | 2-2.5 | 250 | 97 | 3*10(-4) | 170-200 | 2.6 | 0.2-100 |
| 350Y | 8 | 45° | 3.5-4 | 350 | 95 | 2*10(-4) | 240-280 | 2.0 | 0.2-100 |
| 500Y | 6.5 | 45° | 4-4.5 | 500 | 93 | 3*10(-4) | 370-400 | 1.8 | 0.2-100 |
| 125Y | 24 | 30° | 0.8-0.9 | 125 | 98.5 | 1.4*10(-4) | 85-100 | 3.5 | 0.2-100 |
| 250Y | 12 | 30° | 1.6-2 | 250 | 97 | 1.8*10(-4) | 170-200 | 2.8 | 0.2-100 |
| 350Y | 8 | 30° | 2.3-2.8 | 350 | 95 | 1.3*10(-4) | 240-280 | 2.2 | 0.2-100 |
| 500Y | 6.8 | 30° | 2.8-3.2 | 500 | 93 | 1.8*10(-4) | 370-400 | 2.0 | 0.2-100 |
· Main Material:
| Primary Material Main material | Stainless Steel 304, 316, 2205, TA1, etc. The main material is stainless steel 304,316, 205, TA1 and so on. |
Product Information:
The filling diameter range is φ150mm to over 12000mm. Each unit disk has a height of 50-200mm, and the filling is made in block form for diameters exceeding 1.5 meters.
The packing diameter from φ150mm to 12000mm. Each unit has a height of 50-200 mm, if diameter over 1.5 m, and the packing will be made into pads form.
