But reports indicate that China's industrial water reuse rate is only 25%, with severe water pollution and the water environment situation remaining critical. Individuals involved in research and specialized courses also state that the success rate and reuse rate of China's actual industrial wastewater discharge are still very low. Otherwise, the report notes that over a decade ago, most industrial enterprises in China began to construct wastewater treatment facilities for industrial wastewater treatment, but due to low costs and insufficient regulations, many industrial wastewater treatment facilities operate abnormally and emit excessive pollution. Because the industrial wastewater operation and service system is not well-established and there is inadequate supervision, such as limitations in statistics, experts believe the success rate is far lower than the actual industrial wastewater discharge statistics. The issue of treatment remains prominent, and the technical lifespan of equipment is the time from the start of using a batch of equipment until the outdated technology is eliminated.



Generally, for Zhenjiang's internal flow grid plates, if the total flow rate is below 200 m3/h, select a 3kW motor; if the total flow rate exceeds 200 m3/h, use a 4kW motor. The selection of the motor, due to the majority of the time spent in the screen grid exposed to the air, the water level must consider water-cooled motors, wet vehicle and dry vehicle motors, and the maintenance level must exceed IP67-IP68. The heating rate is more suitable for screen破碎 based on monitoring data, as the temperature of the submersible motor rises to about 60 degrees in about 10 minutes, it may continue to rise, and the service life is not long; although a standard waterproof motor may reach 50 degrees in 30 minutes, the temperature will not continue to rise at 55 degrees.

Simple Observation Methods for Equipment Operation

1. Grate Front: Observe the filter screen at the inlet opening, where to buy the inner flow screen plate grate, the left side is the upward filter screen with a lot of debris on the mesh. The right side is the downward filter screen, with a quote for the inner flow screen plate grate, the mesh should be clean and free of particles.

2. Behind the grate: Observe the water flow in the outflow channels on both sides of the grate. When the grate is operating, the water surges and the flow rate is high. Upon stopping, the outflow rate gradually decreases, the internal flow grid plate grate manufacturer, and the flow rate slows down, with the liquid level behind the grate gradually becoming stable.

3. Observe the operation cycle of the grille machine for any abnormal sounds, and listen to ensure the冲击声is loud and forceful during the medium-pressure rinsing.

4. Observe for any abnormal sounds during the operation of the press, and check if the slag and drainage volumes are normal.

Inflow Plate Grating Manufacturer - Zhenjiang Inflow Plate Grating - Nanjing Lansai Environmental Protection Equipment, provided by Nanjing Lansai Environmental Protection Equipment Co., Ltd. The Inflow Plate Grating Manufacturer - Zhenjiang Inflow Plate Grating - Nanjing Lansai Environmental Protection Equipment is a new upgrade launched by Nanjing Lansai Environmental Protection Equipment Co., Ltd. this year. The images above are for reference only. Please call the contact number on this page or the image to request a contact person: Manager Wang Jun. Meanwhile, our company is also a manufacturer of格栅除污机, Nanjing格栅除污机, and格栅除污 machine manufacturers. Welcome to call for inquiries.