The TMR Total Mixed Ration Feed Blender combines roughage, feed, and trace elements, etc., according to the nutritional requirements of different feeding stages for cattle and sheep, to create feed that meets the required standards. It ensures that every bite of the daily ration consumed by the cattle and sheep is stable in roughage proportion and consistent in nutritional concentration. The TMR Feed Blender includes a housing, driving motor, transmission shaft, vertical auger, vertical output shaft sprocket reducer, blades, weighing system, and hydraulic system, featuring a simple structure, ease of use, fast mixing speed, and excellent mixing results.
TMR Full-Ration Feed Blender Advantages:
1. Roughage is mixed uniformly to enhance feed palatability and prevent selective feeding and nutritional imbalance in cows.
2. Beneficial for the synthesis of sugars and carbohydrates, and the utilization rate of proteins.
3. Enhance rumen function, maintain stable rumen pH levels, and prevent rumen acidosis.
4. Maximum dry matter intake of dairy cows, feed conversion rate.
5. Adjust the use of non粗料 flexibly based on the quality and price of roughage.
6. Reduce labor, improve farming efficiency, and facilitate animal husbandry management.
7. Utilize local raw material resources to reduce feed costs.
8. Beneficial for large-scale dairy production.
9. Beneficial for dairy farm biosecurity, reducing the incidence of disease.
TMR Mixer Usage:
1. When using a TMR feed mixer, first select the installation location for both the TMR feed mixer and the power unit; if it's for long-term fixed operations, the unit should be securely mounted on a concrete base.
2. After the base is fully installed, conduct a systematic static inspection of the unit. Then, run the unit under dynamic no-load conditions for 3-5 minutes. If no abnormalities are observed, the unit is ready for operation.
3. For electric-powered equipment, it is necessary to have an electrician properly layout the wiring.
4. Approximately ten days after the TMR feed mixer is put into use, it is necessary to open the cover to inspect the rotating parts such as the impeller and hammer blades, tighten all the connecting screws, and check if the bearings are properly lubricated.
