Product Introduction

A hydraulic coupler is a mechanical device that transmits rotational speed using a liquid medium. It connects the driving input shaft to the original drive, and the driven output shaft to the load shaft. By adjusting the pressure of the liquid medium, the rotational speed of the output shaft can be changed. In an ideal state, as the pressure approaches infinity, the output speed equals the input speed, similar to a rigid coupling. As the pressure decreases, the output speed correspondingly reduces. Continuously changing the medium pressure allows for a stepless adjustment of the output speed below the input speed. The principle of power control and speed regulation, as well as the efficiency of the hydraulic coupler, are based on the aforementioned characteristics. A hydraulic coupler is an energy-consuming mechanical speed regulation device; the deeper the speed regulation (the lower the speed), the greater the loss, especially for constant torque loads. Since the original drive input power remains constant, the loss power increases proportionally with the speed loss. For loads like fans and pumps, where the load torque varies with the square of the speed, the original drive input power decreases with the square of the speed, resulting in relatively smaller loss power. However, the output power decreases with the cube of the speed, and the speed regulation efficiency remains low. The speed regulation efficiency curve of the hydraulic coupler shows an average efficiency of around 50%. A non-rigid coupling that uses a liquid as the working medium, also known as a hydraulic coupling.

Product Real Photos

Product Features

The impeller and turbine of a hydraulic coupling form a sealed working chamber that allows for the circulation of fluid. The impeller is mounted on the input shaft, while the turbine is mounted on the output shaft. As the power source (such as an internal combustion engine or electric motor) rotates the input shaft, the fluid is ejected by the centrifugal impeller. This high-speed fluid enters the turbine, causing it to rotate and transferring the energy obtained from the impeller to the output shaft. The fluid then returns to the impeller, creating a continuous cycle. The hydraulic coupling transmits torque by changing the momentum moment through the interaction of the fluid with the blades of the impeller and turbine. Its output torque is equal to the input torque minus the friction torque, hence it is always less than the input torque. The input and output shafts of the hydraulic coupling are connected by the fluid, without any rigid connections between the working components. The features of the hydraulic coupling include: the ability to eliminate shock and vibration; output speed lower than input speed, with the speed difference between the two shafts increasing with the load; good overload protection and starting performance, allowing the input shaft to continue rotating even when the load is too great to prevent damage to the power source; and when the load decreases, the output shaft speed increases until it approaches the input shaft speed. The transmission efficiency of the hydraulic coupling is equal to the ratio of the output shaft speed multiplied by the output torque (output power) to the input shaft speed multiplied by the input torque (input power). Generally, a hydraulic coupling can achieve higher efficiency when the normal operating speed ratio is above 0.95. The characteristics of the hydraulic coupling vary due to the different shapes of the working chamber and the impeller and turbine. If the oil in the hydraulic coupling is drained, the coupling is disengaged, serving as a clutch.