Product Introduction

This product is a solvent-based formulation with special additives, primarily used for cleaning oil stains, iron shavings, carbon powder, and other contaminants that cause electrical equipment failures.Extend the service life of electrical equipment; prevent equipment failure.

2. Product Features

2.1 Excellent insulation properties, high voltage resistance; can be cleaned while live, without affecting the performance of electrical equipment during the cleaning process.

2.2 Volatile completely with no residue. Also, it is non-corrosive to various materials that make up electrical equipment.

3. Physical Properties

Appearance: Colorless transparent liquid

Density:0.721 

Flash Point: 96℃

4. Product Application

4.1 Electrical Equipment: Used for cleaning motors, generators, switchgear, transformer equipment, switchroom equipment, large electromagnetic valves, switchgear, automatic switches, welders, and low-power manual tools, etc. Cleaning these electrical equipment will not affect the insulation of the equipment.

4.2 Machinery and Equipment: Used for cleaning machinery and equipment, such as hydraulic machinery cylinders, various filters, gearboxes, bearings, hinge mechanisms, etc.Offer a variety of metal components.

5. Instructions for Use

5.1 Spray Wash Method:

Available Spray gun. External connection0.4~0.6MP compressed air. After connecting the spray gun to the compressed air, it is essential to check for moisture in the air. Typically, the following methods are used to confirm:

Observe for fog when empty.

② Spray compressed air onto the dry cement floor to check for water stains.

Spray compressed air onto your palm from a certain distance and feel for any moisture.

If moisture is confirmed in the compressed air, it can affect the cleaning efficiency and even potentially reduce insulation, and it is not suitable for cleaning with electricity.

Before using the cleaning, the dust and impurities adhering to the surface of the electrical equipment should be thoroughly blown off with compressed air, then... Siphon tube for spray gun intakeS-818 should be cleaned, and after cleaning, it should be dried with air or allowed to dry naturally.

Three-step Cleaning Method: Wind WashWashing – Air Drying

5.2 Immersion Method: Directly immerse the components of the small electric motor or various mechanical parts into the container filled with solution. After a few minutes, remove and dry with air or let it air dry naturally. Apply lubricating oil to the parts requiring lubrication.

5.3 Cleaning Methods: For mechanical and electrical equipment that cannot be cleaned with soaking or spray washing, they can be directly wiped or brushed with a brush. After cleaning, air dry or let them dry naturally.

5.4 Direct spray cleaning for steel aerosol can packaging.

 6. Cautionary Notes

6.1 Do not use near open flame; store in a well-ventilated area below 40℃.

6.2 Avoid prolonged skin contact and inhaling large amounts of vapors. If accidentally splashed into eyes, rinse promptly with water.

7. Validity Period

Shelf life: 2 years when packaging is intact

8. Packaging

20L/Bucket25L/Drum Packaging