The electric film winder features a large roll length of 100 meters, with a drive shaft made of Φ25*1.5 thin-walled galvanized pipe.
The electric film roller features lightweight, high output torque, automatic locking, high precision stroke adjustment, wide adjustment range, waterproof, condensation-proof, and low power consumption. It is suitable for use under various climatic conditions and is an excellent choice for modern solar greenhouses.
How to install an electric film roller?
1. Drive pipe for greenhouse installation, cut out about 150mm at one end of the roller shutter, no bending or twisting allowed.
2. Connect the drive shaft coupler and drive steel pipe using M8 hex bolts.
3. The overlapping length between the outer and inner telescopic tubes must not be less than 100mm of the film roll width.
4. The telescopic tube (inner) and the fixed tube should be able to rotate around the fixed steel pipe after being hinged.
5. The side-opening electric reel climbing steel pipe and the drive steel pipe should form a right angle.
































