Test piece embedding machine

Product Introduction

The metallographic specimen embedding machine (hereinafter referred to as the embedding machine) is suitable for pressing thermosetting plastics on small metallographic specimens that are not shaped or easy to handle. After forming, it is convenient to perform sample grinding and polishing operations, and it is also beneficial for microstructure determination under a metallographic microscope.                The embedding machine can work reliably under the following conditions:

1. Altitude not exceeding 1000 meters;

2. The temperature of the surrounding medium shall not exceed+40 degrees Celsius and shall not be lower than -10 degrees Celsius;

3. The relative humidity of the air is not greater than 85% (at 20 degrees Celsius);

4. There are no obvious vibrations or bumps.

5. There is no conductive dust, explosive gas, or corrosive gas that can seriously damage metals and insulation around.

This series of mechanical inlaying machines rotates the external handwheel of the machine body, and drives the internal screw of the machine body through a pair of bevel gears to move the lower mold of the pressed sample up and down inside the steel mold sleeve. The thermal plastic and the embedded sample are formed under heating conditions. The forming pressure during the sample preparation process is automatically compensated by a spring fixed inside the body, and the pressure of the sample compression can be indicated by a signal light. This embedding machine is equipped with a digital temperature controller, which enables real-time temperature display and autonomous temperature setting. It is also equipped with a timer, which enables semi-automatic sample preparation and greatly improves work efficiency. Time for each embedding and sample preparation8-10 minutes, an ideal sample as smooth as a mirror can be obtained.

Technical Specifications