Installation method of flange ring

1. Firstly, it is necessary to close the water valve or main water valve of the toilet, flush out the water in the toilet tank and toilet bowl, and use a sponge or towel to absorb the remaining water in the toilet tank and toilet bowl.

2. Use lubricating oil and pliers to remove the nut cover that secures the toilet bowl to the ground, and at the same time, unscrew the nut.

3. Disconnect the water supply pipe, gently shake the toilet, loosen the wax seal and glass agent, and then be careful to hold the toilet bowl. Do not hold the water tank, otherwise it is likely to cause damage to the connection between the water tank and the toilet bowl.

4. Remove the old wax seal ring on the joint surface of the toilet, disassemble the new flange ring, make it round and upward, and place it on the flange on the ground, making it on the opposite side of the opening, ensuring that the two screws are ready in place.

5. Lift the toilet and place it on the flange and wax seal to keep it level. Sit on the toilet to seal the new flange and keep the toilet bowl level. Reinstall the just removed nut to avoid cracking the bottom of the toilet.

6. Connect the water supply pipe, open the water valve to allow the toilet's water tank to store water, and then flush regularly to see if there is any leakage. In order to make the toilet more secure, glass glue can be applied to the gap between the toilet bowl and the floor, and the installation is completed smoothly.