Nowadays, the application of five lotus flower fire burned boards in engineering construction is becoming increasingly widespread, and buildings decorated with five lotus flower fire burned boards can be seen everywhere in daily life. However, after long-term installation as a natural stone material, problems such as incomplete, perforated, and cracked Wulian flower fire burned boards gradually become apparent. Therefore, we need to promptly address the issues that arise with Wulian flower fire burned boards.
1. The treatment of cracking problems in Wulian flower fire burning board.
Cracks are one of the simple problems that appear after long-term use of the Five Lotus Fire Burnt Plate. To repair cracks in the Five Lotus Fire Burnt Plate, the dirt in the cracks should be cleaned first, then the powder in the cracks should be sucked out with a vacuum cleaner, and then the cracks should be repaired with repair glue.
2. The treatment of the joint problem of Wulian flower fire burning board.
Joint problems may occur during the laying process of Wulian flower fire burned boards. This is because the gaps between the stones inevitably form black seams before processing. Therefore, before renovation, the black seam needs to be cleaned with a needle, blade, or sewing machine, the dirt in the black seam should be sucked out with a vacuum cleaner, and the gap should be filled with marble glue that is close to the color of the stone.
3. The treatment of the problem of missing surface in the Wulian flower fire burning board.
After long-term use, it is inevitable that the Wulian flower fire burned board will have damaged parts, so it is necessary to carry out surface repair treatment. Before repairing, the damaged parts must be cleaned thoroughly and the dust must be removed with a vacuum cleaner. Then, a scrapped five lotus fire board of equal quality (cleaned in the same category) should be used. Cut the incomplete parts into sizes, seal them, and then grind them flat.
4. The treatment of the hole surface of the Five Lotus Fire Burning Plate.
This hole is a damaged part of the Wulian Flower Fire Burnt Plate after long-term use. Of course, before repairing, clean the hole thoroughly, then use a vacuum cleaner to remove dust, and finally crush the lost stones with the same quality. Then clean the stone used for repair, add grease glue to make it slightly higher than the plane by 3-4mm. After the grease glue is completely dry, use a grinder to grind it flat and then renovate it.
This is the repair technique for the Five Lotus Flower Fire Burning Plate. Only by mastering the correct repair techniques can the Wulian flower fire burned board be better maintained, avoid damage, and extend the service life of the stone.