Important Precautions for Operating Used Enamel Reactors: Before powering on a used enamel reactor, we will check the integrity of the wiring and instruments, as well as ensure the motor speed control is set to 0. There are still many precautions to take after the power-on operation of Anhui used enamel reactors. This article provides a brief overview of used enamel reactors.

Before operation, carefully inspect for any abnormalities. During normal operation, do not open the lid or touch the terminal blocks on the board to prevent electric shock.

2. Calibration of measuring instruments should be performed regularly to ensure accurate and reliable operation.

3. The rate of temperature increase should not be too rapid, and pressure should be applied slowly as well, especially the mixing speed, which should only be gradually increased. In the event of a power outage, the speed control knob should be immediately adjusted back to zero.

Do not return cold, as extreme temperature differences may cause damage.

5. During the operation of the second-hand enamel reactor, the water jacket between the coupling and the reactor cover must be circulated with cooling water to control the working temperature of the magnet steel and prevent demagnetization.

Do not hammer or tighten bolt and nut connections under high pressure.

After a period of use, the blast film may become aged and fatigued, reducing the blast pressure and potentially having medium attached, which can affect its sensitivity. It should be replaced regularly, typically once a year, to prevent failure.

Absolutely no pressure disassembly allowed.

We have reached the end of our detailed introduction to the knowledge of second-hand glazed reaction kettles today. We hope this information has been helpful. For more comprehensive insights into second-hand glazed reaction kettles, please continue to follow our website.