This machine can produce non-standard, national standard nuts, flanges, lighter parts, electronic parts, various semi-hollow rivets, full hollow rivets, solid rivets, pull rivets, furniture screws, and stainless steel products. It uses parallel cutting and feeding. The automatic one-time molding system separates finished products from waste material automatically. Our company also produces nut cold heading machines, double-head screw machines, various rivet machines, cylindrical pin cold heading machines, hot forging machines (automatic hot forging machines): utilizing a full solid-state induction heater to heat the material, the machine applies heading and forging pressure, and performs automatic feeding, heating, cutting, stamping, and dropping of materials. This allows for one-time molding in molds, capable of forging spherical, hexagonal, cylindrical, valve bodies, and irregular parts. This process allows for reduced material requirements, cost reduction, one-time molding of products, reduced process steps, and the ability to forge deep holes and multi-hole parts, solving complex part challenges, and continuous production that improves efficiency. This equipment is an ideal solution for cold heading processes that cannot be addressed by conventional methods and represents an upgrade and replacement for the stamping and heating red heading pressure process. Production Efficiency: 5 to 6 times faster than a stamping press, with output reaching 50 to 100 pieces per minute depending on the product. Operators: One person can operate, saving 5 workers compared to traditional stamping presses. Safety: Fully automatic production ensures safety and reliability with no injuries. Production Costs: Utilizes one 60-100 kW full solid-state induction heater and one main machine, saving 30% on electricity. Quality Rate: Product quality rate is 98%, compared to a 90% rate for stamping presses.