ADRS Type Repair Vulcanizer

During the operation of tape conveyor machinery, damage to both sides of the tape can occur due to misalignment or inherent quality issues with the conveyor itself, affecting normal use. The DJQ type electric heating tape edge repairer,

Can perform effective vulcanization repairs to edge damage within a relatively short downtime (typically 3 hours) without removing the idlers. It is a versatile comprehensive repair equipment.

Its performance and operating method are the same as those of a vulcanizer.

Technical Specifications:

1. Sulfurizing Temperature: 145℃

2. Sulfur Pressure: 0.8 Mpa

3. Heating Plate Size: 700×350 (mm)

4. Rated Power: 3.5 kW

Installation Instructions:

① Conduct rubber filling treatment for damaged areas requiring repair (refer to the filling section in the vulcanization process of tape joints, or have the factory service personnel demonstrate during equipment debugging).

② Place the lower shelf below the repair area (levelly), on the shelf, position the water pressure plate beneath the tape, and the lower heating plate (directly above the repair area).

Place a heating plate, an insulating plate, and then the upper machine frame below the repaired area, aligning it with the lower machine frame.

④ Install the handle, washer, and nut, then tighten securely.

⑤ Connect the electrical control box to the power source with one set of wires, and connect the heating plate to the electrical control box with another set of wires. Pay attention to aligning the connections with the labels on the electrical control box.

⑥ Connect the pump to the water pressure plate with a high-pressure hose, turn on the electric control box, and fill the water pressure plate with water to the curing pressure.