FT-109A Fracturing Proppant Bulk Density Tester / Compaction Density Gauge

FT-109A Fracturing Proppant Volume Density Tester | Bulk Density Meter

Reference Standard:

Refer to StandardAPI RP60、Q/SY 124-2007AndSY/T 5108-2006Fracturing Proppant Performance Specifications and Testing MethodsQSY 125-2007Fracturing Proppant Performance Table Creation and Evaluation Test Method

Volume Density: The mass of a support material per unit of bulk volume is known as the support material volume density; the mass of a clay ball per unit of bulk volume is called the clay ball volume density, which is the average density including the clay ball itself, open air pores, and closed air pores. The unit isg/mL

II. Parameter Requirements:

FT-109A Fracturing Proppant Bulk Density Tester, Pile Density Gauge

Funnel mouth to bottom of drum container's deck height304.8mmThe distance from the point of descent of the support material to the instrument's surface.215.9mm；

2.Funnel height76.2mmFunnnel mouth height12.7mmBucket-shaped container height76.2mmInstrument Bench Width=30.48mm。

Rubber Plug Ball Diameter=30.48mm；

Stainless steel bracket diameter=4.8mmBowl-shaped volume diameter38.1mm；

Funnnel top outer diameter=139.7mmFunnnel top inner diameter=114.3mm；

Funnel and measuring cup are made of stainless steel..

Configuration: Brush; Steel Ruler; Level; Instructions; Certificate of Compliance; Warranty Card;

Powder Comprehensive Analysis Solution:

FT-3400Powder Flow Behavior Analyzer (Static Mechanics, Shear Method)

FT-7100Powder Flow Tester (Dynamic Mechanical, Drum Method or Rotating Cylinder Method)

FT-3900Powder Yield Strength Analyzer (Uniaxial Compression Method)

FT-109A Fracturing Proppant Bulk Density Tester | Compaction Density Meter