Installation Key Points for Steel Frame Lightweight Panels

One, the steel-reinforced wire mesh within the steel frame light board uses welded wire mesh with a diameter of 5 and 3, where the 5mm diameter serves as the bearing steel bars, extending into the support for at least 50mm, and the 3mm diameter as the distribution steel bars, extending into the support for at least 30mm. Additionally, there should be transverse steel bars on the support架.

To ensure the integrity of the core material in lightweight steel frame panels, the upper layer should be poured before the lower layer begins to set.

When pouring the core material on the roof surface of the roof panel and the outer side of the wall panel, it should be elevated 20 mm above the steel frame.

The protective layer thickness of the reinforcing steel for steel frame light panels should be ≥20 mm.

Five, it is not permitted to drill holes on steel frame lightweight panels. When the hole diameter exceeds 200mm, it should be designed separately and reserved in advance before production. In special cases, if holes need to be drilled on-site, it must be completed under the cooperation of the manufacturing factory.