Old Wall Demolition Cutting Machine, High-Power Electric Wall Cutting Machine, Concrete Cutting Machine

Old Wall Demolition Cutting Machine, High-Power Electric Wall Cutting Machine, Concrete Cutting Machine

Wall cutting machines are primarily used for building or old building renovations, reinforcement, and design changes. They can cut through large areas of walls, such as door openings, windows, or elevator shafts. Manual feed and cutting. The structure remains intact, forming in one go, which not only avoids damaging the building structure from traditional hammering construction but also saves time and resources on drilling circular holes, as well as significantly reduces the time and cost for finishing.

Key Technical Parameters:

Saw Blade:800mm Cutting Depth: 32cm

Power Voltage:220V, Power: 6200W

Dimensions:100*100*80cm

Product Real Shots Display

Wall cutting machine operation instructions:

Secure the track with expansion bolts, place the machine on the track (the track has teeth, the machine has gears that won't slip, and can only be moved by handwheels), install the blade and the guard, then operate the two handwheels after water and electricity are connected. The middle handwheel controls the up and down movement of the blade, and the right-hand handwheel controls the machine's movement along the track.

Our wall cutting machines feature heavy-duty double-insulated high-power motors and reducers, with low failure rates, long service life, and cost savings on maintenance.      Mechanical clutch protector, effectively preventing damage to the machine and personnel due to improper operation. Equipped with manual or automatic cutting control, it not only improves construction quality but also accelerates work speed, while significantly reducing the labor intensity for the operator.

Machine Installation

First install the moving track, then place the machine onto the track.To facilitate horizontal wall cutting, the correct installation of the sliding track is as follows: the motor should face upwards and the blade downwards. During cutting, the rotation direction of the blade should be as opposite as possible to the motor's running direction. This not only reduces the cutting time but also improves the cutting efficiency.

First, drill a hole with a hammer drill at a position approximately 165mm away from the self-sealing cut, creating a fixed hole for a 16.3-16.5mm diameter expansion bolt with a depth of 55mm. This hole is designed to accommodate only one M12 expansion bolt included with the machine. The track can be installed and used in any direction around the hole.

2. Clean out the small debris inside the holes with a pneumatic gun.

3. Insert the M12 expansion screw provided with the machine, then use a mallet to tap it into the expansion screw hole, and hammer it to secure the expansion screw.  Ensure that the expansion bolts are securely fastened in the holes; otherwise, the machine may move or fall off during operation. Use the expansion bolts and screws, as well as the fixed guide rails provided with this machine, and determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly.