详情描述

Fully Automatic Hydraulic Wall Saw (Construction Site) - Wall Cutting Machine for Engineering Use

The wall cutting machine is mainly used for building renovations, reinforcement, design changes, etc., capable of cutting large areas of walls for door openings, windows, elevator shafts, and more. It features manual feeding and cutting. The structure remains unharmed, forming in one go, which not only avoids structural damage from traditional hammering construction but also saves time and resources on drilling circular排孔 holes, as well as significantly reduces downtime and costs.

Key Technical Parameters:

Saw blades:800mm Cut Depth: 32cm

Power Voltage:220V, Power: 6200W

Dimensions:100*100*80cm

Actual product photo display

Wall cutting machine operation instructions:

Secure the track with expansion bolts, place the machine on the track (the track has teeth, the machine has gears that prevent slipping, and can only be moved by handwheels), install the blade and the protective cover. Once water and electricity are connected, operate the machine using both handwheels. The middle handwheel controls the blade's up and down movement, while the right-hand handwheel controls the machine's movement along the track.

Our wall cutting machines feature heavy-duty dual insulation high-power motors and reducers, boasting low failure rates, long service life, and cost savings on maintenance.      Mechanical clutch protector, effectively preventing damage to the machine and personnel due to misoperation. Equipped with manual or automatic cutting control devices, it not only improves construction quality but also accelerates the construction speed, while significantly reducing the labor intensity of the operator.

Machine Installation

First, install the track, then place the machine on the track.To achieve horizontal wall cutting, the correct installation of the sliding track is: the motor should face upwards and the blade downwards. During cutting, the rotation of the blade should be as opposite as possible to the motor's running direction. This not only reduces the cutting time but also improves the cutting efficiency.

1. First, drill a hole with a hammer drill at approximately 165mm from the self-cutting position, creating a fixed hole for a 16.3-16.5mm diameter, 55mm deep expansion screw. This hole is designed to accommodate only one M12 expansion screw included with the machine. The track can be installed and used in any direction around the hole.

2. Clean out the small debris inside the holes with a blow gun.

3. Insert the M12 expansion screw provided with the machine, then tap the screw into the expansion screw hole with a mallet, and hammer it to secure the expansion screw.  Ensure that the expansion bolts are securely fastened in the holes; otherwise, the machine may move or fall off during operation. Use the expansion bolts and bolts provided with this machine, and the fixed guide rails, to determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly.

4. When installing the main unit, align it with the forward indicator on the unit. Connect the speed controller and the plug in sequence, then turn the handwheel counterclockwise to move the main unit along the track.

5. Insert the blade; the main spindle has a diameter of 35mm. The hexagon screws for securing the blade  Open-end wrench  Tighten.