详情描述

Wall Cutting Machine, Masonry Saw for Door and Window Installation, Reinforced Concrete Cutting Machine

Wall cutting machines are primarily used for building renovations, reinforcement, and design changes, capable of cutting large areas of walls such as door openings, windows, and elevator shafts. Manual feeding and cutting. The structure remains undamaged, forming in one go, which not only avoids the damage to the building structure caused by traditional hammering work but also saves time, materials, and labor compared to drilling circular排孔 methods, as well as a significant amount of time and costs for adjustments.

Main Technical Parameters:

Saw Blade:800mm / Cutting Depth: 32cm

Power Voltage:220V, Power: 6200W

Dimensions:100*100*80cm

Product Real Photo Display

Wall cutting machine operation instructions:

Secure the track with expansion bolts, place the machine on the track (the track has teeth, and the machine has gears that won't slip, so it can only be moved by handwheels), install the blade and the guard, then operate the two handwheels after water and electricity are connected. The middle handwheel controls the up and down movement of the blade, and the right-hand handwheel controls the machine's movement along the track.

Our wall cutting machines feature heavy-duty dual insulation high-power motors and reducers, offering low failure rates, long service life, and cost savings on maintenance.      Mechanical clutch protector, effectively preventing damage to the machine and personnel due to improper operation. Equipped with manual or automatic cutting control devices, it not only improves construction quality but also accelerates work speed, while significantly reducing the labor intensity of the operator.

Machine Installation

First install the traveling track, then place the machine on the track.To achieve horizontal wall cutting, the correct installation of the track is: the motor should face up and the blade should face down. During cutting, the rotation direction of the blade should be as opposite to the motor's running direction as possible. This not only reduces the cutting time but also improves the cutting efficiency.

1. First, drill a hole for a 16.3-16.5mm diameter expansion bolt at a depth of 55mm, approximately 165mm from the initial cutoff point made by the hammer drill. This hole is designed to fit only one M12 expansion bolt included with the machine, and the track can be installed and used in any direction around the hole.

2. Clean out the small debris inside the holes with a blow gun.

3. Insert the M12 expansion screw provided with the machine, then tap the screw into the expansion screw hole with a mallet, and hammer it to secure the expansion screw.  Ensure that the expansion bolts are securely fastened in the holes; otherwise, the machine may move or fall off during operation. Use the expansion bolts and screws, as well as the fixed guide rails provided with this machine, and determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly.

4. When installing the main unit, align it with the forward indicator on the unit. Connect the speed controller and the plug in sequence, then turn the handwheel counterclockwise to move the main unit along the track.

5. Insert the saw blade; the main body's inner hole is 35mm. Six-pointed screws for securing the saw blade  Open-end wrench  Secure.

6. Align the saw blade with the cutting line and position the track for movement.  Adjust the horizontal level of the six hexagon head bolts on the moving track with a hexagon wrench, moving them up and down to level the track. This prevents the track from derailing at the joining point.