Wire Rope Core Conveyor Belt Vulcanizing Head剥皮机 for Coal Mines, Utility-Specific

Steel Wire Rope Core Conveyor Belt Vulcanizing Head Stripper for Coal Mines, Power Plants Use

This equipment is used for the preparation of vulcanized joints on steel wire rope conveyor belts, facilitating the separation of steel wire rope cores from rubber. It can be used in various occasions and locations where bonding is required, greatly shortening the working time needed for bonding steel wire rope core conveyor belts and effectively reducing the labor intensity of operators. Suitable for wire rope spacing≤25mm,Diameter ofφ4.9～φ13.2mmSteel wire rope core conveyor belt,Covered rubber layer thickness, bearing surface25mm,Non-carrier face12mm,Total Tape Thickness≤43mm。

Two,Technical Specifications:

1.Motor Power:3000W

2.Operating Voltage:380V

3.Line Speed:0.3m/s

4.Wire rope diameter:φ4.9～φ13.2mm

5.Convey thickness:≤43mm

III. Features:

1.No need to flip the belt, as the wire rope is covered with rubber both above and below.Clearing Can be completed in one go.

2.The thickness of residual adhesive on the steel wire can be arbitrarily controlled to ensure vulcanization strength.

3.Compared to traditional manual deheading methods, it's more user-friendly, saving a significant amount of time, and greatly reducing labor intensity.

IV. Structure:

This equipment is divided into an electric traction section and a working section. The electric traction section operates the working section via a钢丝 rope.

FiveInstructions for Use:

1.Confirm the head剥头dimension and mark the lines as shown in the drawing.

2.Peel out at the underlined position with a knife.200mmBroad bare wire rope;Two-bolt joint belt section   

Side requirementClearing Rubber, as per the露出钢丝绳 standard.

3.Select suitable cutting knives based on the wire rope diameter.

4.Adjust剥头机① Confirm if the upper and lower blades are parallel. ② The pressure roller is aligned vertically with the lower blade. ③ The horizontal distance between the upper and lower blades is the wire rope spacing (loosen the bolt on the upper blade holder, move the position of the upper blade).After the actuating mechanism is tightened, adjust the distance between the pressure roller and the lower blade by turning the bolt. Ensure the wire rope stripping is even from top to bottom.

5.Hold with the blade down   Raw steel wire rope, clamped by the manipulating mechanism, initiates the electric traction machine's cutter movement, which can evenly strip the rubber off the steel wire rope.

6.The top blade holds two steel wire ropes, the bottom blade grips one, the control mechanism tightens, the electric traction machine activates the blade movement, which can evenly strip the rubber from the steel wire ropes, thus peeling off the rubber one by one from inside.

Six: Usage Precautions:

1.The power connector must be handled by a professional electrician.

2.Secure the剥头机 during use to prevent sliding.

3.Confirm that the upper and lower blades are securely fastened. If not, it may damage the blades.

4.The upper and lower blade spacing should match the wire rope spacing; otherwise, the blades may be damaged.

5.Are the upper and lower blades parallel, and is the pull position appropriate?

6.Ensure even and continuous pulling during traction.

 Feature:Preparation work before vulcanization of steel wire rope core conveyor belts.

 Features:1 No need to flip the belt, as the steel wire is covered with rubber on both sides.Clean up Can be completed in one go.

The thickness of residual adhesive on the 2 steel wires can be arbitrarily controlled to ensure vulcanization strength.

Compared to traditional manual head removal methods, it's easier to operate, saving a significant amount of time and greatly reducing labor intensity.