详情描述

Steel Rope Core Stripper Machine, Explosion-Proof Electric Belt Stripper, Layered Tape Skinning Machine

This equipment is used for the preparation of vulcanized joints on steel wire rope conveyor belts, specifically designed for separating steel wire from rubber in steel wire rope cores. It can be used in various situations and locations where bonding is required, with its convenient operation significantly reducing the working time needed for bonding steel wire rope cores, effectively reducing the labor intensity of the operators. Suitable for steel wire spacing≤25mm,Diameter ofφ4.9～φ13.2mmWire Rope Core Conveyor Belts,Covered rubber layer thickness, load-bearing surface25mm,Non-bearing surface12mm,Total Tape Thickness≤43mm。

Two,Technical Specifications:

1.Motor Power:3000W

2.Working Voltage:380V

3.Line speed:0.3m/s

4.Wire rope diameter:φ4.9～φ13.2mm

5.Convey thickness:≤43mm

III. Features:

1.No need to flip the belt, as the rubber cover on the wire rope is pre-installed.Clearing Can be done in one go.

2.The thickness of residual adhesive on the steel wire can be arbitrarily controlled to ensure vulcanization strength.

3.Compared to traditional manual deheading methods, it's more user-friendly, saving a significant amount of time, and greatly reducing labor intensity.

IV. Structure:

This equipment is divided into an electric traction section and a working section. The electric traction section operates the working section through a steel cable.

FiveUsage Instructions:

1.Confirm the headstock size and mark as shown in the diagram.

2.Peel out at the underlined position with a knife.200mmExpanse bare steel wire rope;Two belt joints   

Side requirementClearance Rubber, to expose the steel wire rope.

3.Select appropriate upper and lower knives based on the wire rope diameter.

Wire Rope Diametermm

3.0-5.5

6-7.5

8-8.5

9-9.5

10-10.5

10.5-11.5

12-13.2

Blade tip radiusmm

3

4

4.5

5

5.5

6

6.5

4.Adjust剥头机：① Confirm whether the upper and lower blades are parallel. ② The pressure roller is aligned vertically with the lower blade. ③ The horizontal distance between the upper and lower blades is equal to the wire rope spacing (loosen the bolt on the upper blade clamp to move the position of the upper blade). ④After the actuating mechanism is tightened, adjust the distance between the pressure roller and lower blade with the adjusting bolt. Ensure the wire rope head剥is evenly distributed up and down.

5.Hold with the blade down   Rope core, with the operating mechanism clamped, the electric traction machine's cutting tool moves to uniformly strip the rubber from the rope.

6.Hold the upper blade against two steel wire ropes and the lower blade against one, tighten the operating mechanism, start the electric traction machine, and the blade will uniformly peel off the rubber from the steel wire ropes, peeling off one by one from the inside.