详情描述

BPJ-3 Belt Peeling Machine / Conveyor Belt Skin Stripper / Explosion-proof Electric Layer Peeler

This equipment is divided into the electric traction section and the working section. The electric traction section operates the working section through steel cables.

Five,Usage Instructions:

1.Confirm headstock size and mark as shown in the diagram.

2.Peel out at the underlined position with a knife.200mmExtruded steel wire rope;Two-belt junction part   

Side RequirementClearing Rubber, as per the露出钢丝绳 standard.

3.Select appropriate upper and lower blades based on the wire rope diameter.

Wire rope diametermm

3.0-5.5

6-7.5

8-8.5

9-9.5

10-10.5

10.5-11.5

12-13.2

Dull blade arc radiusmm

3

4

4.5

5

5.5

6

6.5

4.Adjust剥壳机：① Verify if the upper and lower blades are parallel. ② The pressure roller and lower blade are on the same vertical line. ③ The horizontal distance between the upper and lower blades is the wire rope spacing (loosen the bolt on the upper blade holder and move the upper blade position). ④After the actuating mechanism is tightened, adjust the distance between the pressure roller and the lower blade by turning the bolt. Ensure the wire rope head剥is evenly distributed up and down.

5.Press with the blade   Steel wire rope, the actuating mechanism clamps down, the electric traction machine's cutting tool moves, and the rubber on the wire rope can be uniformly removed.

6.The upper blade holds two steel wire ropes, the lower blade grips one, the operating mechanism is tightened, and the electric traction machine's cutting tool is activated, allowing for the even removal of rubber from the steel wire ropes, peeling off the rubber layer by layer from the inside.

Six: Usage Precautions:

1.The junction power supply must be handled by a professional electrician.

2.Secure the peeler machine during use to prevent sliding.

3.Confirm that the upper and lower blades are securely fastened. If not, it may damage the blades.

4.The spacing between the upper and lower blades should match the spacing of the steel wire rope; otherwise, the blades may be damaged.

5.Are the upper and lower blades parallel, and is the traction position appropriate?

6.Apply even and continuous traction.

 Function:Preparation work for vulcanizing joints on steel wire rope core conveyor belts.

 Features:1 No need to flip the belt, as the rubber is applied on both sides of the steel wireClear out Can be completed in one go.

The thickness of residual glue on the 2 steel wires can be arbitrarily controlled to ensure vulcanization strength.

Compared to traditional manual deheading methods, it's easier to operate, saves a significant amount of time, and greatly reduces labor intensity.