详情描述

It drives the abrasive wheel machine M3050, Diamond Electric Abrasive Wheel Machine, Vacuum Dusting Wheel Machine.

1.The grinding wheel machine must rotate in the correct direction, allowing the chips to fly away from the wheel downwards only. 2After the grinding wheel machine is started, grinding should only be performed once the machine has rotated smoothly. If the machine exhibits significant vibration, it should be stopped and adjusted immediately.3The abrasive wheel machine bracket and abrasive wheel should maintain3mmKeep a safe distance to prevent the workpiece from piercing and causing an accident.4When grinding, stand on the side of the grinding wheel machine and avoid excessive force.5Select a grinding wheel that matches the spindle speed of the grinding machine according to the instructions provided.6New grinding wheels must have a factory certification or inspection and test mark. Do not use the wheel if any defects such as quality issues, hardness, grain size, or cracks are found before installation.7When installing the grinding wheel, the clearance between the inner hole of the grinding wheel and the main shaft should not be too tight. It should be adjusted according to the technical requirements for loose fit, generally controlled at0.05?/FONT>0.10Within millimeters.8The grinding wheel must be fitted with flanges on both sides, with a diameter not less than one-third of the grinding wheel's diameter. A gasket should be properly placed between the grinding wheel and the flange.9When tightening the nut, use a specialized wrench. Do not over-tighten it, and strictly avoid hammering with hard objects to prevent the grinding wheel from cracking.10After the grinding wheel is installed, protective guards, baffles, and brackets should be attached. The gap between the baffles, brackets, and the grinding wheel should be maintained at>3Within millimeters, and slightly below the center of the grinding wheel.11Do not rush when starting a new abrasive wheel; first, give it a gentle test run, then proceed.5?/FONT>10After a minute of trial rotation, it can be used.12Do not apply excessive force during the initial grinding to avoid uneven stress on the grinding wheel and potential accidents.13Prohibition on grinding materials such as copper, lead, and wood to prevent sandwheel clogging.14When sharpening, the person should stand on the side of the grinding wheel, and it is not allowed for two people to sharpen on the same wheel simultaneously.15Long-time sharpening knives should be cooled promptly to prevent burning.16Regularly adjust the balance of the grinding wheel surface to maintain good condition.17Grinders should wear protective goggles.18Vacuum cleaner                  Intact and valid; report any malfunctions promptly.  Never stop sharpening the axe.