Automatic Reinforced Concrete Cutting Wall Machine, Industrial Grade Wall Saw, Long-term Supply

Automatic Reinforced Concrete Cutting Wall Machine, Industrial Grade Wall Saw, Long-term Supply of Wall Cutting Machines

Wall cutting machines are primarily used for building renovations, reinforcement, and design changes, capable of cutting large areas of walls such as door openings, windows, and elevator shafts. Manual feeding and cutting. The structure remains intact, forming in one go, which not only avoids the damage to the building's structure caused by traditional hammering work but also saves time, materials, and labor compared to drilling circular排孔 methods.

Main Technical Parameters:

Saw Blade800mm Cutting Depth: 32cm

Power Voltage:220V, Power: 6200W

Dimensions:100*100*80cm

Product Real Photo Display

Wall cutting machine operation instructions:

Secure the track with expansion bolts, place the machine on the track (the track has teeth, and the machine has a gear that won't slip off, movement is only possible with the handwheels), install the blade and the protective guard. Once water and electricity are connected, operate the two handwheels: the middle handwheel controls the up and down movement of the blade, and the right-hand handwheel controls the machine's movement along the track.

Our wall cutting machines feature heavy-duty double-insulated high-power motors and reducers, offering low failure rates, long service life, and cost savings on maintenance.      Mechanical clutch protector, effectively preventing damage to the machine and personnel due to improper operation. Equipped with manual or automatic cutting control, it not only enhances construction quality but also accelerates work speed, significantly reducing the labor intensity for the operator.

Machine Installation

First, install the track, then place the machine on the track.To ensure horizontal wall cutting, the correct installation of the track is: the motor should face up and the blade should face down. During cutting, the rotation direction of the blade should be as opposite to the motor's running direction as possible. This not only reduces the cutting time but also improves the cutting efficiency.

First, drill a hole with a hammer drill at approximately 165mm from the self-separating cut, creating a 16.3-16.5mm diameter, 55mm deep expansion screw mounting hole. This hole is designed to accommodate only one M12 expansion screw included with the machine. The rail can be installed and used in any direction around the hole.

2. Clean out the small debris inside the holes with a pneumatic gun.

3. Drive a M12 expansion screw into the machine, then insert the mallet into the expansion screw hole and tap it with a hammer to secure the screw.  Ensure that the expansion bolts are securely fastened in the holes; otherwise, the machine may move or fall off during operation. Use the expansion bolts and screws provided with this machine along with the fixed guide rail, and determine the number of expansion bolts based on the softness of the cutting surface. Track Secure firmly.