Daze Power 500A Diesel Generator Welding Machine TO500A-J

Unable to achieve separate output power for power generation and welding,Causing unnecessary waste. At the same time, in order to increase the welding current,Having to increase the engine speed during welding,Causing a change in the output frequency of power generation,Causing inconvenience to the simultaneous use of power generation and welding. Due to the limitation of welding winding output power,The load duration of its welding is relatively low,Restricted the ability to work continuously. Welding adopts50/60Hz rectification,After filtering, the output has a large ripple,Not conducive to improving the quality of welding products. The power generation welding machine adopts a common power generation winding for power generation and welding. Through high-frequency inverter technology, the power generation output is converted into the required voltage and current for welding, significantly reducing the size, weight, and loss of the welding machine, and improving the overall efficiency of the welding machine,Due to working at high frequencies, the welding penetration is strong,Depth of molten pool,It has the characteristics of easy arc initiation, small spatter, stable current, and good forming, which is conducive to improving the quality of welding products.

Maintenance:

1Remember not to let the welding machine motor get damp and store it in a dry place. When storing, cover with oilcloth or other materials to prevent moisture from entering.

2Try to avoid the intrusion of dust, water droplets, metals, or other debris during storage or operation.

3Do not cover other debris on the motor during operation to avoid obstructing heat dissipation and causing the motor to overheat and burn out.

4Always pay attention to the heating condition of the motor, and be careful not to load current and voltage.

5Regularly check for any abnormal sparks in the collector ring. If there is any abnormal noise during motor operation, it should be checked immediately.

6Silicon rectifier components should be kept well ventilated, and there should be no obstructions to heat dissipation on the radiator and casing.

7Regularly clean the dust and dirt on all parts, check all fastening screws to prevent loosening.

8Regularly check the control circuit for any loose solder joints, broken ends, or loose screws.