Flake dryer
Our company has developed a flint dryer tailored to the characteristics of flint. It features reasonable drying design, stable process performance, high yield, and low energy consumption.
I. Working Principle
Slightly inclined and rotatable cylinder, wet material enters from the top end, and dry material is collected from the bottom end. Hot air enters from either the feed or discharge end and exits from the top end of the opposite side.
The drum is equipped with forward scraper plates, causing the material to be continuously lifted and sprinkled as the drum rotates, allowing it to fully contact the hot air flow to enhance drying efficiency and advance the material forward.
The heat source for drying materials is typically hot air, high-temperature flue gas, etc. The specific choice can be made based on the properties and quality requirements of the material.
II. Performance Features
Moisture evaporation capacity increases with the rise in hot air temperature and varies with the moisture properties of the material. High thermal efficiency.
The equipment operates smoothly and reliably, with no fragile parts, minimal breakdowns, and a long service life, making it widely used across various drying industries.
Section 3: Application Scope
1. Centrifugal dewatering filter cakes, pressure filter cakes; drying of free-flowing powders, granules, sheets, fibers, and other materials.
2. Widely used for drying materials in a variety of applications, including construction materials, feldspar, fluorspar, quartz sand, iron powder, phosphate rock powder, chemical products (cement plants), fertilizers, compound fertilizers, organic powders, feed, wine lees, spray-dried bran, starch residue, corn bran, and fruit pomace.
Four: Product Features:
Continuous operation, high production capacity.
2. Hot air flow through the cylinder has low resistance and energy consumption.
3. High operational flexibility and strong adaptability to materials.
4. Runs smoothly, minimal failures, low maintenance costs, and long lifespan.
5. Suitable for sticky materials with the addition of tamping and discharging equipment.
6. Utilizes an external instantaneous heating method, ensuring material purity, high cleanliness, and superior results.
7. Requirements for feldspar without iron can be met by using stainless steel materials in production.
