Complete electrical control system, digital display for output pressure, set upper and lower limits, and pressure holding time.

Compared to the previous pneumatic boost unit, this electrically controlled gas power unit configures electronic components based on the on-site conditions. It can display the input and output pressure media on a digital gauge with an accuracy of up to 0.01 Mpa. It sets the upper and lower limits of the output pressure and the pressure-holding time. The boost pump increases the pressure of the purified gas to the test piece. When the upper pressure limit is reached, the pump stops working and a pressure-holding timer starts. During this period, as long as the output pressure does not drop to the lower limit, the test is deemed passable. An alarm sounds, and the load can be released. If a leak occurs during the pressure-holding period and the pressure drops below the lower limit, the boost pump starts to replenish pressure, bringing it back to the upper limit. At this point, the equipment can be turned off to check for leaks.

Low noise, low cost of investment, energy-saving:

Compared to manual supercharger units and single supercharger pumps, this machine boasts lower noise, higher control accuracy, reduced operator involvement, lower cost of investment, precise output pressure, and lower energy consumption, thus saving energy.

Easy to install and use:

Electro-pneumatic gas pressure boosting units are for both pneumatic and electric control systems, connecting to the drive gas inlet, pressurized gas inlet, and the outlet of pressurized gas to operate; set the upper and lower output parameters and pressure holding time, and you can infinitely control the pressure of the pressurized gas without adjusting the drive gas source pressure. They can fill with pure gases, special gases, etc., forming a complete pneumatic gas pressure boosting unit that only requires connection of components. The maximum working pressure reaches 14,500 psi. These pneumatic gas pressure boosting units can be used for various pressure tests and provide a stable power source for work holding fixtures. They include a triple valve pressure regulator, which incorporates a combination filter and water separator, a pressure regulator, and a pressure gauge, allowing direct control of the maximum output pressure limit.

The Deko supercharger requires compressed air to drive and can generate pressure. It can be connected to the existing compressed air pipeline system on-site and powered on with AC220V.

Please contact our staff for the matching circuit and connection diagrams for this unit.