Complete electrical control system, digital display for output pressure, set upper and lower limits, and pressure holding time:

Compared to the previous pneumatic pressure boosting unit, this electro-controlled gas power unit configures electronic components based on the on-site operating conditions. It can display input and output pressure media on a digital gauge with an accuracy of up to 0.01 Mpa. It allows setting the upper and lower limits of output pressure and the pressure holding time. The booster pump boosts the pure gas after boosting to the testing component. When the upper pressure limit is reached, the booster pump stops working and starts pressure holding timing. During the pressure holding period, as long as the output pressure does not drop to the lower limit, it proves the test is passed. An alarm buzzer sounds, and unloading can be performed. If a leak occurs during the pressure holding period, the pressure drops below the lower limit, the booster pump starts to replenish pressure, boosting the pressure back to the upper limit. At this point, the equipment can be turned off to check for leaks.

Low noise, low cost of investment, energy-saving:

Compared to manual supercharger units and single supercharger pumps, this model features lower noise, higher control accuracy, reduced operator intervention, lower cost of investment, precise output pressure, and lower energy consumption, thus saving energy.

Easy to install and use:

Electro-pneumatic gas booster units are designed for both pneumatic and electric control systems, connecting to the drive gas inlet, boosted gas inlet, and boosted gas outlet for operation; by setting the output upper and lower limit parameters and pressure maintenance time, the pressure of the boosted gas can be infinitely controlled without adjusting the drive gas source pressure. They can be filled with pure gases, special gas media, and are a complete pneumatic gas booster unit, ready to use once components are connected. The maximum working pressure reaches 14,500 psi. Pneumatic gas booster units are suitable for various pressure tests and provide a stable power source for workholding fixtures. They include a three-way pressure regulating valve, which features a combination filter and water separator, a pressure regulating valve, and a pressure gauge, allowing direct control of the maximum output pressure.

The Deko supercharger requires compressed air to drive and can produce pressure. It can be connected to the existing compressed air pipeline system on-site and powered on with AC220V.

Please contact our staff for the matching circuit and connection diagrams for this unit.