Comprehensive electrical control system, featuring digital display for output pressure, setting of upper and lower limits, and pressure holding time.

Compared to the previous pneumatic pressure booster unit, this electro-controlled gas power unit configures electronic components based on the on-site operating conditions. It can display the input and output pressure media on a digital gauge with an accuracy of up to 0.01 Mpa. It allows for setting the upper and lower output pressure limits and the hold time. The booster pump increases the pressure of the purified gas after boosting and sends it to the test piece. When the upper pressure limit is reached, the booster pump stops working and the hold time is counted. During the hold period, as long as the output pressure does not drop below the lower limit, it indicates a passing test. An alarm buzzer sounds, and the load can be released. If a leak occurs during the hold period and the pressure falls below the lower limit, the booster pump starts to replenish pressure, bringing it back to the upper limit. At this point, the equipment can be turned off to check for leaks.

Low noise, low cost of investment, energy-saving:

Compared to manual supercharger units and single turbochargers, this model boasts lower noise, higher control precision, reduced operator intervention, lower cost of investment, accurate output pressure, and low energy consumption, resulting in energy savings.

Easier to install and use:

Electro-pneumatic gas pressure boosting units are designed for both pneumatic and electric control systems, connecting to the drive air inlet, pressurized gas inlet, and the outlet of pressurized gas to operate; by setting the upper and lower output parameters and pressure holding time, the pressure of the pressurized gas can be infinitely controlled without adjusting the drive air source pressure. It can fill pure gases, special gas media, etc., making it a complete pneumatic gas pressure boosting unit that only requires connection of components. The maximum working pressure reaches 14,500 psi. The pneumatic gas pressure boosting unit is suitable for various pressure tests and providing a stable power source for workholding fixtures. It includes a triple valve pressure regulator, which incorporates a combination filter and water separator, a pressure regulator, and a pressure gauge, allowing direct control of the maximum output pressure limit.

The Deko supercharger requires only compressed air to generate pressure. It can be connected to the existing compressed air pipeline system on-site and powered on with AC220V.

Please contact our staff for the配套原理图 and connection diagram for this unit.