National Supply of Alcohol Gas Alarms

Operation Principle: The detectors installed on-site are powered by the controller. In the event of a gas leak, the RBK-6000-ZL9 type Combustible Gas Alarm Controller converts the leak amount into a corresponding voltage signal for output. The voltage signal is then processed by the detector and uploaded to the controller. Upon receiving the data, the controller decodes it and displays it on the screen. When the concentration reaches the set trigger value, the controller triggers an alarm and drives an external device.

Key Technical Specifications

Installation Method: Wall-mounted for non-explosion-proof environments

Working Voltage: Main Power: AC 220V ±15%, 50-60Hz

Backup Power: 36VDC/2.2Ah

Power Consumption: ≤10W

Operating Temperature: 0°C to 40°C

Operating Temperature: -10°C to 50°C

Operating Humidity: 10%RH ~ 95%RH

Capacity: ≤9

Signal Transmission: 36V, Bipolar Two Bus

Cable Connectors: ≥RVS 2*2.5mm

2 (Twisted Pair)

Signal Transmission Distance: ≤1000m

Alarm Sound: ≥75dB

Alarm Methods: Audio and Visual Alerts

Audio Alarm: Separate alarms for fault and concentration.

Photo Alarm: LED display for system status (alarm, fault), power status (main power failure)

Faults, power backup issues, charging faults

Linked Output: Two relay outputs (capacity: 5A/250VAC or 5A/30VDC), one set

To maintain a normally open and normally closed state, another set is a pulse-type normally open and normally closed.

Upper communication interface: RS485 bus communication interface (optional), supports Modbus/RTU protocol