The X Series Single-Stage Scroll Vacuum Pumps are a new product in China, designed to remove large amounts of steam. Thanks to the oil regeneration unit and reliable gas trap within the pump, the lifespan of the pump oil is extended. They serve as the basic equipment for obtaining vacuum by removing gases from sealed containers and are suitable for electronic device manufacturing, vacuum drying, filtration, immersion, coating, welding, smelting, and laboratory equipment.

Features:

1. Compared to the XD series single-stage vacuum pump, it offers higher ultimate vacuum. For slide valve vacuum pumps, noise can be controlled by adjusting the silencing needle valve. Due to its small eccentric mass of the rotor and the balancing of the rotor, vibration is minimal.

2. The X Series scroll vacuum pumps offer high exhaust efficiency.

3. The X series scroll vacuum pump boasts excellent gas trapping performance.

The X Series scroll vacuum pumps feature a specially designed gas separator that can infuse dry gas into the exhaust chamber, significantly reducing the partial pressure of steam in the discharge gas. Once it falls below the saturation vapor pressure at the pump temperature, it can be discharged along with the air, thus preventing condensation within the pump.

4. The X series scroll vacuum pumps are equipped with a temperature-controlled water volume regulating valve.

During operation, by adjusting the water pressure with the pump's own equipment as mentioned above, the pump temperature can be set to 75°C ± 5°C, thereby increasing the temperature of the discharge outside the pump. However, the pump temperature should not exceed 80°C (temperature measurement point at the oil tank).

5. The X Series rotary vane vacuum pumps come equipped with an oil-water separator.

It allows impurities and sediment in the pump oil to accumulate at the bottom of the oil-water separator, where they can be drained out of the pump through a water drain valve installed at the bottom.

Model X-100/X-150