Sunward Electrical is a technology-based manufacturing enterprise.,Please provide the Chinese content to be translated.2015Established annually, the company is located in Jiangsu, China./Yangzhou, Baoying County, Liubao Industrial Zone.Scope of Business:Yangzhou Shunye Electrical Co., Ltd. specializes in the production of insulating materials and is a supplier code for China Aluminum.:gy423102aProviding high-quality products to numerous large domestic enterprise groups:China Aluminum Corporation, China Hongqiao Group, State Power Investment Corporation, Shanghai Electric Group, Panzhihua Iron and Steel Group Co., Ltd., China Dongfang Electric Corporation Limited, Southern Power Grid Company, Baoyao Group, No.22 Construction Engineering Group, No.7 Construction Engineering Group, No.17 Construction Engineering Group, etc.HP8Mica Sheets are boards or rolls of insulating material made by baking, pressing, and winding high-quality mica paper or phlogopite paper with non-curing organic silicone resin.(It can also be reinforced on both sides with alkali-free glass fiber cloth for electrical purposes.)Excellent bending strength and processing performance; the product boasts high bending strength and toughness.*Pressed into various shapes without delamination.HP8Mica boards, common issues during the cow production process:
(1)Surface Gasket(Wood acrylic speckle)Surface adhesive occurrence,Primarily, the solvable parts of the adhesive tape are too large.,High Volatile Organic Compounds (VOCs):Low pre-drying temperature of wool,Time is insufficient.,Mao is still acting when the temperature is low.:Due to reasons such as excessive and forceful pressure during clamping. Use only qualified adhesive tape.,When the solubility resin content of the adhesive tape is too high,Volatile matter is high.,Increase the pre-drying time appropriately.,Let more volatiles escape,Typical pre-drying temperature should not be lower than100℃. Dummy assembly,Mold temperature100° C or so,Not too low and not too high,After mold closing, the pressing should be slow.,This has a certain effect on solving the issue of adhesive on the surface area.
(2)The surface texture is mainly due to the low solvable resin content in the adhesive tape.,After dressing, the slow extrusion speed or insufficient hair quality.,Utilize qualified tape,When it is found that the solubility resin content of the adhesive tape is too low,Preheat temperature reduced.,Time appropriately shortened,Lower mold temperature,After mold closing, the pressing should be faster. This can help to some extent in resolving surface pitting. Insufficient rough casting quality causes surface pitting.,Ensure quality supplementation(3)End and internal cracking are mainly due to the high content of resin and volatile substances in the adhesive tape's soluble parts.,Pre-drying temperature and time are not reasonable.,For rubber sheets with exceptionally high content of soluble resins and volatile substances, it is advisable to extend the pre-supply time to remove more volatiles. However, the pre-drying time should not be too long.,Resin may crack even after curing and gelation.,To tailor to the specific circumstances,Analyze the cause,Extend the pre-drying time appropriately.
