Gravel polymer artistic flooring is divided into fine aggregate washed sand artistic flooring and coarse aggregate gravel flooring. It is made by thoroughly mixing fine aggregates, glass stones, cement, and special reinforcing agents and dyes, then laid out uniformly. After treatment with a special surface钝化reactant, it is cleaned and then chemically dyed with professional high-permeability materials to achieve artistic effects such as stone-like, cracked earth, beach-like, ocean gradient, cartoon patterns, and more. The product's artistic effect is lifelike and provides anti-slip properties, making it widely used for flooring in various amusement parks, ocean parks, and theme parks.
Gravel polymer flooring is often used in places like playgrounds and parks, where the desired effect is typically achieved by laying granite, marble, and other stone materials. However, generally speaking, stone sizes are standardized, and during installation, larger-radius turns often require the stones to be cut into smaller pieces for assembly. This not only makes the process complicated and environmentally unfriendly but also leads to significant waste of stone during cutting, and the result is often not ideal. Moreover, the paving of stone surfaces has independent blocks, with poor overall load-bearing capacity and vulnerable edges that are prone to damage.
Aggregate concrete exposed aggregate finishes are typically available in two methods:
Washing: Utilize a light-controlled water spray combined with a stiff brush for scrubbing to remove the surface layer of mortar, until the fine particles of aggregate in the concrete are exposed.
b. Retarding Agent: By applying an approved surface retarding agent solution to the concrete finish, it influences the setting of the surface mortar, removes the mortar surface, and then clears the retarding agent solution by washing with water and/or wiping, revealing the aggregates and achieving the desired surface texture.
Another expression of gravel concrete is: broadcasting aggregate finish.
Please provide the Chinese content you would like translated into American English.A decorative aggregate overlay applied over plastic concrete. The aggregate particles should be uniformly sized and should be washed prior to installation. Distribute the aggregates evenly on the surface, then press them into the concrete using a trowel or a straightedge. Begin applying immediately after treating the concrete with a straightedge, compacting the aggregates until they are fully embedded in the concrete surface. Treat the exposed aggregates with a water wash or retardant method.
Polymer aggregate concrete is produced by adding polymer enhancing agents during the concrete mixing process, optimizing the aggregate concrete mix ratio. The surface of polymer concrete is then smoothed or leveled, with various types and sizes of aggregates broadcasted on the surface. When bleeding occurs, a long-handled trowel or scraper is used to smooth the surface until it is flat and smooth. Once the polymer concrete has gained sufficient strength, the surface is brushed to expose the previously broadcasted aggregates to varying degrees, creating a variety of gravel scenes to achieve the desired effect.
