STDZ-1 Rock Point Load Tester Overview:

A point load tester places rock specimens between two spherical conical plates, applying a concentrated load until failure, then calculating the point load strength of the rock based on the failure load. The point load strength can serve as an indicator for rock strength classification and rock mass weathering classification, as well as for evaluating the degree of anisotropy in rock strength. It can also be used to estimate other strength indicators related to it, such as uniaxial compressive strength and tensile strength, etc.

Point load strength tests are applicable to all types of regular or irregular rocks, including core samples from drilled holes, outcrops, exploration trenches, adits, and tunnels. This test individually determines the point load strength of rocks in their natural state.

STDZ-1 Rock Point Load Attachment Main Parameters:

1. Conical sphere end spherical curvature: r=5mm

2. Apex Angle of Cone: 60°

3. Conical Material: High-quality steel, hard.

4. Jack working pressure: 50-100 MPa.

5. Load Sensor Range: 50-100 KN

6. Axial Travel: Greater than 100mm.

7. Built-in Battery: Suits continuous operation in the wilderness.

8. Display Type: Digital Display

Approximately 30 kg.

Product Images:

STDZ-1 Rock Point Load Fixture Main Parameters:

1. Spherical Curvature at the Ball End of the Cone: r=5mm

2. Apex Angle of Cone: 60°

3. Cone Material: High-quality steel, hard.

4. Jack working pressure: 50-100 MPa

5. Load Cell Range: 50-100KN

6. Axial Stroke: Greater than 100mm

7. Built-in Battery: Suits continuous operation in the wilderness.

8. Display Type: Digital Display

9. Approx. 30 kg.