I. ConceptA non-ferrous metal separator is a magnetic separation equipment used for continuously recovering copper, aluminum, zinc, and other non-ferrous metals in granular and lump forms. It is suitable for selecting copper and aluminum from industrial waste, construction waste, treating domestic garbage and pollutants, material handling in non-ferrous metal processing, copper, aluminum, and zinc recovery from shredded auto parts, recycling of used electrical appliances, and other related copper and aluminum recycling industries.The internal structure is constructed with state-of-the-art technology, utilizing a magnetic system made of strong neodymium iron boron permanent magnets, featuring strong magnetic field, energy-saving, easy maintenance, and convenience in use.Section 2: Main Structure and Working Principle1. Main StructureThe machine is mainly composed of an external drum, eccentric roller, magnetic roller drive motor, reducer, idle roller, annular integrated belt, vibrating screen, and frame.2. Working PrincipleMaterial is fed from the self-vibrating screen, transported along a belt to the magnetic roller area. Inside, the magnetic roller rotates at high speed. Conductors (non-ferrous metals) within the material generate induced currents in the high-frequency alternating magnetic field. This current creates a magnetic field opposite to the original field, exerting a strong repulsive force on the non-ferrous metals, which are instantaneously ejected from the material, achieving the separation goal.Section 3: Partial Technical Specifications Dimensions are as per actual size.

IV. Installation and Commissioning1. The magnetic separator is composed of a drive unit, roller, vibration feeder, and other components.2. Magnetic separators should be installed on a level, sturdy concrete or steel foundation. Ensure the stability of the separator's support feet and even distribution of force to prevent frame deformation caused by uneven ground.3. Check if the motor is running normally and in the correct direction.4. Check if the voltage is normal, the insulation is good, and if the magnetic separator is grounded.5. Inspect for any foreign objects that may hinder the roller operation; only proceed with motor operation after they are removed.6. Adjust the magnetic system's bias angle based on the iron removal efficiency to achieve the optimal iron removal performance.V. Operation ProceduresEnsure power connection to guarantee the machine is properly powered and free of any alarms.Manual method1. Turn on the internal magnetic roller with a touch screen and rotate the roller speed button to gradually increase the speed of the roller2. Once the internal roller reaches the required speed, start the belt-driven motor.3. Once the belt operates normally, start the vibration screen.4. Feed material only after the vibrating screen has stabilized in operation.Automatic Mode1. Tap the touchscreen to start automatically2. Feed material only after the machine has automatically activated the internal magnetic roller, belt, and vibration screen.Upon equipment activation, the internal magnetic roller rotates at high speed. Conductors (non-ferrous metals) within the material generate induced current in the high-frequency alternating magnetic field. This current produces a magnetic field opposite to the original field, exerting a strong repulsive force on the non-ferrous metals, which are then instantaneously ejected from the material, achieving the separation objective.Six, Cautionary Notes and Consumable Parts1. The reducer starts operating until 400 hours, then the lubricating oil should be changed. The subsequent oil change cycle is approximately every 4000 hours.2. Ensure sufficient lubricating oil is retained in the reducer housing and perform regular inspections.3. There are two oil filling nozzles at each end of the magnetic roller. Add high-speed grease daily during machine operation!4. Promptly repair or replace the belt if damage is found during use.5. Prior to equipment operation, ensure the machine feet are stable and even to prevent equipment misalignment, damage, and safety accidents.6. In the event of any abnormal phenomena in the motor during operation, such as smoking, strange odors, or abnormal working current and voltage, the power should be immediately disconnected for inspection. The motor can only be put back into operation after the cause is identified and the fault is eliminated.7. Once the equipment is operating normally, regularly check for loose fasteners and tighten them if necessary.8. When rubber aging leads to reduced sealing function and minor oil leakage, replace the oil seal and replenish the lubricant.