I. ConceptA non-ferrous metal separator is a magnetic separation equipment used for the continuous recovery of copper, aluminum, zinc, and other non-ferrous metals in granular and lump form. It is suitable for selecting copper and aluminum from industrial waste and construction debris, treating household waste and pollutants, material handling in non-ferrous metal processing, recovering copper, aluminum, and zinc from shredded automotive scrap, recycling of electronic waste, and other related copper and aluminum recovery industries.The internal structure is constructed using cutting-edge technology, with the magnetic system composed of strong neodymium-iron-boron permanent magnets, featuring a strong magnetic field, energy-saving, easy maintenance, and convenient use.Part Two: Main Structure and Working Principle1. Main StructureThis machine is primarily composed of an external drum, eccentric roller, magnetic roller drive motor, reducer, idler roller, annular integrated belt, vibration screen, and frame.2. Operating PrincipleMaterial is fed from the vibrating screen to the belt conveyor, which transports it to the magnetic roller. The internal magnetic roller rotates at high speed. Conductors (non-ferrous metals) within the material generate induced currents in the high-frequency alternating magnetic field. This current produces a magnetic field opposite to the original field, exerting a strong repulsive force on the non-ferrous metals, which are then instantaneously ejected from the material, achieving the separation goal.Section 3: Partial Technical Specifications Dimensions are as per actual.

IV. Installation and Commissioning1. The magnetic separator is composed of a drive unit, a drum, a vibration feeder, and other components.2. Magnetic separators should be installed on a level, sturdy concrete or steel foundation. Ensure the stability of the separator's support feet and even distribution of force to prevent frame deformation caused by uneven ground.3. Check if the motor is running normally and in the correct direction.4. Check if the voltage is normal, insulation is good, and the magnetic separator is properly grounded.5. Inspect for any foreign objects that may hinder the roller operation; remove them before starting the motor.6. Adjust the magnetic system bias angle based on the iron removal effect to achieve the ideal iron removal performance.V. Operational ProceduresPower on to ensure the machine is properly powered and free of alarms.Manual method1. Turn on the internal magnetic roller with a touch screen and rotate the roller speed button to gradually increase the speed of the roller2. Once the internal magnetic roller reaches the required speed, start the belt-driven motor.3. Once the belt operates normally, start the vibration screen.4. Feed material can only be introduced after the vibration screen has stabilized in operation.Automatic Mode1. Tap the touchscreen to start automatically2. Feed material only after the machine has automatically activated the internal magnetic roller, belt, and vibration screen once.Upon equipment activation, the internal magnetic roller operates at high speed. Conductors (non-ferrous metals) within the material generate induced currents in the high-frequency alternating magnetic field. The magnetic field produced by this current is opposite in direction to the original field, exerting a strong repulsive force on the non-ferrous metals, causing them to be instantaneously ejected from the material, thereby achieving the separation goal.Six. Cautionary Notes and Consumable Parts1. The reducer should be re-lubricated after 400 hours of operation, with subsequent oil change intervals approximately every 4000 hours.2. Ensure there is sufficient lubricant in the reducer housing and check it regularly.3. There are two oil nozzles at each end of the magnetic roller. Add high-speed grease daily during machine operation!4. Promptly repair or replace the belt if damage is found during use.5. Prior to equipment operation, ensure that the machine feet are firmly and evenly positioned to prevent equipment misalignment, damage, and safety hazards.6. In the event of any abnormal phenomena in the motor during operation, such as smoking, strange odors, or abnormal working current and voltage, the power should be immediately disconnected for inspection. Only after the cause is identified and the fault is eliminated can the motor be put back into operation.7. Once the equipment is up and running, regularly check for loose fasteners and tighten them if necessary.8. When rubber aging leads to reduced sealing function and minor oil leakage, replace the oil seal and replenish the lubricant.