I. ConceptA non-ferrous metal separator is a magnetic separation equipment used for the continuous recovery of copper, aluminum, zinc, and other non-ferrous metals in particle and lump form. It is suitable for selecting copper and aluminum from industrial waste and construction waste, treating household waste and pollutants, handling materials in non-ferrous metal processing, recovering copper, aluminum, and zinc from shredded automotive parts, recycling old electrical appliances, and other related copper and aluminum recovery industries.The internal structure is crafted using cutting-edge technology, featuring a magnetic system composed of powerful neodymium-iron-boron permanent magnets. It boasts strong magnetic fields, energy-saving, easy maintenance, and convenience in use.Section II: Main Structure and Working Principle1. Main StructureThis machine is primarily composed of an external drum, eccentric roller, magnetic roller drive motor, reducer, idler roller, annular integrated belt, vibration sieve, and frame.2. Operating PrincipleMaterial is fed from the vibrating screen to the belt conveyor, which transports it to the magnetic roller. The internal magnetic roller rotates at high speed. Conductors (non-ferrous metals) in the material generate induced current in the high-frequency alternating magnetic field. This current creates a magnetic field opposite to the original field, exerting a strong repulsive force on the non-ferrous metals, which are then instantaneously ejected from the material, achieving the separation.Section 3: Partial Technical Specifications Dimensions are as actual.

IV. Installation and Commissioning1. The magnetic separator consists of a drive unit, drum, vibration feeder, and other components.2. Magnetic separators should be installed on a level, sturdy concrete or steel foundation. Ensure the stability of the separator's support feet and even distribution of force to prevent frame deformation due to uneven ground.3. Check if the motor is running normally and in the correct direction.4. Check if the voltage is normal, insulation is good, and the magnetic separator is grounded.5. Inspect for any foreign objects that may hinder the roller operation, and only proceed with motor operation after they have been removed.6. Adjust the magnetic system bias angle based on the iron removal effect to achieve the ideal iron removal performance.V. Operating ProceduresEnsure power connection for normal machine operation and no alarm activation.Manual method1. Turn on the internal magnetic roller with the touch screen and rotate the speed control button to gradually increase the roller speed2. Once the internal roller reaches the required speed, start the belt-driven motor.3. After the belt operates normally, start the vibration screen.4. Feed material can only be introduced after the vibrating screen has stabilized its operation.Automatic Mode1. Tap the touchscreen to start automatically2. Wait until the machine automatically turns on the internal magnetic roller, belt, and vibration screen before feeding materials.Upon equipment activation, the internal magnetic roller operates at high speed. Conductors (non-ferrous metals) within the material generate induced currents in the high-frequency alternating magnetic field. The magnetic field produced by this current is opposite in direction to the original field, exerting a strong repulsive force on the non-ferrous metals, causing them to be ejected from the material instantly, achieving the separation goal.Section 6: Precautions and Consumable Parts1. The reducer starts running to 400 hours before being re-lubricated; subsequent oil change intervals are approximately every 4,000 hours.2. Ensure sufficient lubricating oil is retained in the reducer housing and check it regularly.3. There are two oil nozzles at each end of the magnetic roller. Add high-speed grease daily during machine operation!4. Promptly repair or replace the belt if damage is found during use.5. Prior to equipment operation, ensure the machine feet are stable and even to prevent equipment misalignment, damage, and safety accidents.6. If abnormal phenomena such as smoking, strange odors, or abnormal working current and voltage are detected during operation, the power should be immediately turned off for inspection. Only after the cause is identified and the fault is rectified can the motor be put back into operation.7. Once the equipment is up and running, regularly check for loose fasteners, and tighten them if necessary.8. When rubber aging results in reduced sealing and minor oil leakage, replace the oil seal and replenish the lubricant.