I. ConceptA non-ferrous metal separator is a magnetic separation equipment used for continuously recovering copper, aluminum, zinc, and other non-ferrous metals in granular and lump form. It is suitable for selecting copper and aluminum from industrial waste, construction and demolition debris, treating domestic waste and pollutants, material handling in non-ferrous metal processing, recycling copper, aluminum, and zinc from shredded auto parts, recycling of electronic waste, and other related copper and aluminum recycling industries.The internal structure employs cutting-edge technology, with the magnetic system composed of strong neodymium iron boron permanent magnet materials, featuring strong magnetic field, energy-saving, easy maintenance, and convenient use.Part Two: Main Structure and Working Principle1. Main StructureThis machine is primarily composed of an external drum, eccentric roller, magnetic roller drive motor, reducer, idler roller, annular integrated belt, vibration screen, and frame.2. Working PrincipleMaterial is fed from the vibrating screen to the magnetic roller via a belt conveyor. The internal magnetic roller rotates at high speed, causing conductive materials (non-ferrous metals) in the material to generate induced currents in the high-frequency alternating magnetic field. This current produces a magnetic field opposite in direction to the original field, exerting a strong repulsive force on the non-ferrous metals, which are then instantaneously ejected from the material, achieving the separation goal.Section 3: Partial Technical Parameters Dimensions are as per actual measurements.

IV. Installation and Commissioning1. The magnetic separator consists of a drive unit, a drum, a vibration feeder, and other components.2. Magnetic separators should be installed on a level, sturdy concrete or steel foundation. The feet of the separator should remain level and evenly distributed to prevent deformation of the machine frame due to uneven ground.3. Check if the motor is running normally and in the correct direction.4. Check if the voltage is normal, the insulation is good, and the magnetic separator is grounded.5. Inspect for any foreign objects that may hinder the roller operation; only proceed with motor operation after they have been removed.6. Adjust the magnetic system bias angle based on the iron removal effect to achieve the desired iron removal performance of the equipment.V. Operation ProceduresPlug in the power to ensure the machine is properly powered on and free of any alarm signals.Manual method1. Turn on the internal magnetic roller with a touch screen, then rotate the roller speed button to gradually increase the speed of the magnetic roller2. Once the internal roller reaches the required speed, start the belt-driven motor.3. Once the belt operates normally, start the vibration screen.4. Feed material only after the vibration screen has stabilized in operation.Automatic Mode1. Tap the touchscreen to start automatically2. Only after the machine automatically starts the internal magnetic roller, belt, and vibration screen can feeding begin.Once the equipment is turned on, the internal magnetic roller rotates at high speed. Conductors (non-ferrous metals) within the material generate induced currents in the high-frequency alternating magnetic field. The magnetic field produced by these currents is opposite in direction to the original field, exerting a strong repulsive force on the non-ferrous metals, causing them to pop out of the material instantly, thus achieving the separation goal.Section 6: Precautions and Consumables1. The reducer starts running and after 400 hours, the lubricating oil should be changed. Subsequent oil change intervals are approximately every 4000 hours.2. Ensure sufficient lubricating oil is retained in the reducer housing and inspect it regularly.3. There are two oil nozzles at each end of the magnetic roller. Add high-speed grease daily during machine operation!4. Promptly repair or replace the belt if any damage is found during use.5. Prior to equipment operation, ensure the base is stable and even to prevent equipment misalignment, damage, and safety accidents.6. If any abnormal phenomena are detected during operation, such as smoking, strange odors, or abnormal working current and voltage, the power should be immediately shut off for inspection. Only after the cause is identified and the fault is eliminated can the motor be put back into operation.7. Once the equipment is operating normally, regularly check for loose fasteners and tighten them if necessary.8. When rubber aging leads to reduced sealing function and minor oil leakage, replace the oil seal and replenish the lubricant.