Primarily for the pumping of water glass. For the standard CO2 water glass process, the water glass addition is approximately 6-8% (by weight of sand); for the vacuum CO2 water glass process, the addition is around 3-4% (by weight of sand). Consequently, based on the characteristics of the standard CO2 and CO2 water glass processes, L-series carbon steel pumps are selected for the transportation of CO2 water glass.

Advantages

The rotor component features helical anti-fouling grooves on its surface to prevent the pump from being jammed by crystalline deposits.

Highly resistant to corrosion, abrasion, and high adhesion.

Gears are made of a combination of soft and hard materials, offering excellent avoidance of fine sand particles.

The gear pump's design speed adequately accommodates the viscosity characteristics of water glass.

Material: Carbon Steel.

Sealed; packed seal.

Installation: Motor installation, base foot installation.

Pressure: 1~70 bs (depending on viscosity).

Viscosity: Reaches 100,000 p5.

Temperature: -18 ~ 200°FC (If temperature exceeds 90)C, please specify in the selection process)

Typical Applications

Foundry Industry: Water Glass, Furfuryl Resin.

Fiber Industry: Resins, dyes, etc.

Adhesives Industry: Oxidizing Agents, Adhesives.

Performance Parameters Table:

Note: The above parameters are measured at a pump inlet and outlet pressure of 0bar. (Special requirements can be customized.)