Product Introduction:

This series of products is made by adding DuPont Teflon high-temperature resistant new material, which is processed at high temperatures. It has the advantages of wear resistance, high temperature resistance, and good printing effect. It has good elasticity, strong flexibility, and long service life. Even for irregular surfaces with fine patterns, it can ensure clear printing effect. Completely stained ink, easy to remove ink transfer, and residual ink is easy to remove. Complete specifications, easy to customize according to specific user requirements.

Product Usage

Mainly used for printing irregular patterns on ceramic products, it is easy to apply oil and has elasticity without deformation. Transfer printing adhesive head is to use the pattern on the steel plate as a carrier through the adhesive head, and then transfer the pattern on the steel plate to the toy product

Printing Silicone Product User Manual

1、 First, clean the mold with detergent, then dry the moisture in the mold and apply a layer of release agent.

2、 The normal ratio of silicone and silicon oil for transfer printing is determined according to the customer's requirements. If the customer requires a large printed pattern area and a soft rubber head is needed, additional silicon oil should be added. On the contrary, for those that require high hardness of the rubber head, silicone oil should not be added or added less. Generally, the hardness of the transfer printing rubber head is suitable between 15A~-25A °. If the amount of silicone oil added is too large and the rubber head is too soft, the number of printing times will be limited. Even the best quality of silicone oil will be destroyed by the silicone oil, resulting in its molecular weight being damaged, leading to wear resistance, solvent resistance, and aging.

3、 The normal ratio is as follows: 100g of silicone oil is added to 30g of silicone oil, which is suitable for transfer printing alloy cars and products with small patterns and relatively small contact areas. If a large pressure contact surface is required or a soft rubber head is needed, the ratio of silicone oil to silicone oil can range from 100:30 to 100:50. However, it should be noted that the larger the amount of silicone oil added, the softer the rubber head, and the number of transfer printing times, wear resistance, and solvent resistance will be reduced. The number of transfer printing products will also be correspondingly reduced, resulting in increased costs and waste of raw materials.

4、 The dosage of curing agent and the chemical reaction of silicone are as follows: Take 100g of silicone oil and 50g of silicone oil, then mix and stir. After the silicone oil and silicone oil are thoroughly stirred, add curing agent at 2% -3% of the total weight of silicone oil and silicone oil, stir for 2-3 minutes, and then evacuate. The evacuation time is generally not more than 10 minutes. If the evacuation time is too long, the gel will solidify quickly, which will affect the quality of the poured gel.