Basic Parameters of Dehumidifying and Drying Oven for Hardware Parts:
1. Internal cavity dimensions: Length 6000mm x Width 700mm x Height 300mm
2. Insulation Material: Outer shell made from Q235-1.5T sheet metal folded, inner lining of SUS304 stainless steel plate; 100mm rock wool insulation.
3. Temperature Range: RT ~ 200℃
4. Temperature fluctuation: ±1℃
5. Temperature uniformity: ±5℃ (no-load test)
6. Heating Rate: RT-200℃ ≤ 15min
7. Shell Temperature: ≤60°C, excluding the edges around the seams.
8. Hot air recirculation method: The circulation fan is equipped with a propeller to stir and circulate the air.
9. Power supply: Three-phase five-wire system, 380V, 50Hz
10. Heating Power: 36 kW
11. Electrical Configuration: Sanyou temperature controller, Migel SSR, Schneider low-voltage electrical appliances.
12. Hot Air Circulation Fan: Dongde aluminum shell agitator motor with SUS304 stainless steel impeller.
13. Heater: Domestic stainless steel heater
14.配套设施: High-pressure fan with stainless steel water-removing air knife.