Serial Number NO | Performance properties | Unit unit | Indicator standard | Inspection Results result |
1 | Appearance | Phenolic mold plastic sample powder must not contain any impurities or dirt; the sample should have a bright and smooth surface. | Meets | |
2 | Volume Coefficient | ≤3.0 | 2.79 | |
3 | Relative Density | g/cm³ | ≤1.45 | 1.42 |
4 | Impact Strength (Notched) | KJ/m2 | ≥1.5 | 2.79 |
Impact Strength (Not Chipped) | KJ/m2 | ≥6.0 | 6.9 | |
5 | Hot deformation temperature | ℃ | ≥180 | 181 |
6 | Bend Strength | MPa | ≥70 | 79 |
7 | Insulating Resistance | Ω | ≥10 | 2.15*10 |
8 | Dielectric strength | MV/m | ≥10 | 10 |
9 | Dielectric Loss Factor | ≤0.1 | 0.05 | |
10 | Absorbency
| mg | ≤50 | 43 |
11 | Shrinkage rate | % | Buyer and seller negotiate | 0.8 |
12 | Liquidity | mm | Buyer and supplier negotiate | 215 |
13 | Dielectric Tracking Index | / | / | |
14 | Combustion Performance (Burning Wire Method) | / | / |
Data is for reference only.
