Frame-type wave inclined plate sedimentator
Product Introduction
Wavy Plate settlersUtilizing corrugated plates instead of flat plates offers the advantages of enhanced rigidity and ease of support. Flat plates save materials, with parallel corrugated slats placed at equal intervals within the slanted end face frame. They are secured to the frame by curved supports, forming a corrugated plate assembly unit. The material for both the corrugated plates and the frame is food-grade.ABSOr rigid PVC or stainless steel, with an inclined angle of the slant board55-60Degree, the wavelength of the waveguide plate500mm,Wave Height100mmSkew plate spacing40mm-100mm.
【Working Principle】
Frame-type wave inclined plate sedimentatorBy utilizing the theory of shallow sedimentation, the sedimentation area is increased with inclined plates, thereby shortening the distance between the sedimentation pond and the inclined plates for particle sedimentation.0. 04Within a mileThe side flow sedimentation pond is the preferred choice, with water flowing horizontally. The sludge settling on the inclined plate slides downward vertically, perpendicular to the water flow, which does not interfere with the sludge's descent, facilitating mud-water separation. The water flows in a wave pattern between the corrugated plates, and due to the variation in wave gaps, it provides conditions for the particles to continue agglomeration and growth. The frame-type corrugated inclined plate sedimentation unit is an optimal choice for counterflow inclined plate sedimentation ponds. The sludge settling on the plate concentrates into mud strings at the troughs of the corrugated plates, significantly enhancing the sludge's descending performance, reducing mud accumulation, shortening the cleaning cycle of the plates, and extending their service life.
【Technical Specifications】
Lateral flow
1:Slant board spacing60mm,Inclination angle55-60Degrees.
2:Design Flow Rate5-20mm/s.
3:Approximate Volume Load10㎡/㎡.hr.
4:Hydraulic retention time5-7Minute.
Counterflow
1:Inclined plate spacing40-100mm
2:Rising flow rate1. 5-6mm
3:Inclined plate, slant length1000-1500mm
Product Specifications: Inclined Plate Angle55-60Degree, inclined plate spacing40-1000mmSlant plate dimensions:B=1000-1500mm H=819-1300mmOblique length =1000-1500mm
Under the conditions of the aforementioned technical parameters, after the frame-type wavy plate sedimentator is set to the required quantity, it can be stacked at will in the sedimentation pond, forming various pond shapes. Generally, the wavy plate assembly is stacked longitudinally.2-4Unit, not to exceed4A unit, with3A unit is quite suitable.。Vertical flow baffles should be installed above and below the board assembly. The top end of the board assembly is generally submerged under water.100mm. Generally, a reciprocating hydraulic sludge scraper under the wave-shaped plate assembly and a submersible sludge scraper are used for mud removal.
