Product Name:

Product Name: LaiBo Vacuum Pump Oil

Brand: Leybold (Germany)

Model No.: LVO100

Size: 1L, 5L, 20L, 208L

Product Specifications:

Category:Vacuum Pump Oil

Viscosity Coefficient:100

Brand:Lebo

Weight Ratio:0.88

Shine Points:260（℃）

40℃ Kinematic Viscosity:95（cSt）

Pour Point:-12（℃）

Model No.:LVO100

Product Showcase:

Lepow Technical Specifications Sheet:

Lai Bo Vacuum Pump Oil Common Models:

Product Performance:

Excellent antioxidant and thermal stability, significantly extending the service life of lubricants.

Low-carbon tendency, effectively prevents the formation of胶质 and carbon slag.

Low vapor pressure and volatility ensure an appropriate vacuum level within the vacuum pump.

Excellent wear protection and good anti-foaming, air release properties.

Cautionary Notes:

Vacuum pump oil has a shelf life of up to 3-5 years under sealed conditions; unopened, it is guaranteed for 3 months.

After the initial 500 hours of use, replace the pump oil. Thereafter, change the oil every 1000-1500 operating hours. (Note: In harsh operating environments, it is necessary to frequently observe the color of the pump oil.)

Check the oil level sight glass; if the oil turns from yellow-brown to black or milky white, it's time to replace the vacuum pump oil.

Selecting the appropriate vacuum pump oil will greatly benefit the pump's ultimate differential pressure, ultimate total pressure, startup, power consumption, pump temperature, stability of pump performance, and the service life of the vacuum pump.

Vacuum Pump Oil Change Method

1. Loosen the drain valve using the gravity method, raise the pump body oil tank to allow the old oil in the vacuum pump to automatically flow to the rotating oil cap position and drain. After the old oil is completely drained, inject a small amount of clean vacuum pump oil (100~500mL) from the vacuum pump oil filling port, flushing the internal cavity. Then, run the vacuum pump for about 1 minute, turn it off, and drain the newly injected oil. If the drained oil is still not clean, continue to inject new oil for flushing until it is clean.

Next, unscrew the oil drain valve, remove the oil filling cap from the filling hole, add new vacuum pump oil into the vacuum pump until the oil level reaches the oil mark, and then tighten the filling cap.

Our services

Product Selection Consultation -- Vacuum System Customization -- Vacuum Technology Consultation -- Maintenance Service Contract -- Extended Warranty Service