Four (Six) Degrees of Freedom Vibration Table HC-ZD-500

ProductProduct Overview:

    The Vibration Test Bench series is widely applicable to factors encountered during assembly, transportation, and use, simulating the product's capabilities under harsh vibration conditions. It is used for vibration inspections in quality system certifications for industries such as communication, electronics, automotive, household appliances, and toys. This type of equipment is suitable for detecting early faults, simulating actual working conditions for evaluation, and conducting structural strength tests. This series can also be used for scientific research and vibration resistance check tests on production lines for various products, providing a strong and reliable guarantee for your product quality.

Product Features:
1、Vibration Features: ①Vertical ②Horizontal ③Front-Back ④Sequential Actions (Vertical→Horizontal, Vertical→Front-Back, Horizontal→Vertical, Horizontal→Front-Back, Front-Back→Vertical, Front-Back→Horizontal) ⑤Random Vibration ⑥Simultaneous Vertical, Horizontal, and Front-Back Vibration.
2. Frequency Tuning Function: Set any frequency within the frequency range.
3. Sweep Function: (Upper Frequency/Lower Frequency/Time Range) is adjustable.
4. Programmable Features: Any adjustment for 1 to 15 segments, with each segment customizable (frequency/time) for continuous looping.
5. Frequency Doubling Function: Adjust from 1 to 15 stages, increasing in multiples. ① Low to High Frequency ② High to Low Frequency ③ Low to High and then Low Frequency / Can be Cycled.
6. Logarithmic Function: Adjust from low to high frequency, from high to low frequency, and from low to high then to low frequency – 3 modes of logarithmic/cyclic, adjustable.
7. Display Amplitude Acceleration: To view amplitude, acceleration, maximum acceleration, and precise values, a separate measuring instrument must be purchased (additional purchase required).
8. Full-featured computer control: To connect the computer for control, storage, recording, and (optional printing) functions, a separate interface card program computer (additional purchase) is required.
9. Vibration Table Surface Dimensions: 500×500×10:mm. The surface features 25 10mm threaded holes and four corners with approximately 7cm long hook holes on each side.
Note: Fixed frequency 50Hz with no frequency modulation, sweep, programmable, frequency doubling, and logarithmic functions.

Product Specifications:

• Model: Four (Six) Degree of Freedom Vibration Table HC-ZD-500

• Amplitude: <4mm

• Welded screw holes: 25 M10 threaded holes

• Frequency Range: 50Hz, 1-600Hz, 1-3000Hz, 1-5000Hz

• Load Capacity: 80 kg

• Vibration Direction: XYZ Axis

• Vibration Table Surface Dimensions: 500×500×10mm

Product Images: