3D Electromagnetic Interference Visualization System WM9500CE

Product Introduction

High precision 3D detection of EMC interference can achieve multi angle analysis of the interference source.

WM9500CE detects the position of XYZ in space through an infrared sensor and can measure the electromagnetic waves scattered from the detected object.

1. Equipped with a dedicated stereo camera, confirm the images captured by the camera on the PC and determine the measurement area.

2. Hold the probe and aim it at the desired location to set an infrared marker. The three-dimensional grid with a measurement range of one to tens of centimeters can be arbitrarily divided. With the arbitrary movement of the probe, the interference map can be displayed and stored on the computer as a result

From this, it can be seen that "WM9500CE" can obtain essential data for analyzing the location of interference occurrence, transmission direction, frequency components, etc.

Product Features

Not affected by the measurement site and the object being measured. Due to the use of infrared recognition coordinates, there are no special restrictions on the measurement environment and location, and it is completely unaffected by the brightness of the measurement site and the color of the detected object. Thus, interference detection can be achieved from individual components to complete products.

For example, small and dark places such as the engine compartment and trunk of a car can also achieve interference detection.

WM9500CE utilizes handheld methods to effectively utilize measurement maneuverability while easily obtaining detailed and multi-faceted detection data.

Application field

This system can be widely applied in industries such as automobiles, air conditioners, refrigerators, microwaves, routers, servers, etc.

Product Parameters

Measurement range: recommended to be around 0.6m-2m, with a viewing angle of 56 °

Measurement method: Obtain spatial coordinates based on infrared reflection method (850nm)

Lens: High definition lens with autofocus function

Detection position accuracy: ± 1mm (recommended at a distance of 2m)

Measurement spacing: 1mm (can be set arbitrarily in the control software settings)

Host: W400 * 109 * 124 (mm)

Controller: W320 * 280 * 94.5 (mm)

Control method: Connect the USB 2.0 interface for control

Voltage: AC100V-240V

Power: 60VA (MAX) (excluding spectrum analyzer)

Controller: Use a dedicated computer for control.