Product Introduction

The equipment used for testing high-pressure/steam jet cleaning protection according to ISO 20653 standard meets the protection levels IPX9-IPX9K of DIN40050 and IEC 60529 standards

Product Parameters

1. The equipment structure adopts a stainless steel square tube frame with a stainless steel sealing plate at the bottom.

2. The waterproof box frame is made of anodized aluminum profiles, and the surface is sealed with transparent organic glass.

3. The waterproof box door is equipped with a safety micro switch. The height of the sample turntable can be adjusted, the diameter of the table tray is 280mm, and the turntable speed is 5 ± 1rpm

4. Column bracket with vertical and vertical adjustment, equipped with 4 fixed position nozzles, with spray angles of 0 ° -30 ° -60 ° -90 ° converging at the center.

5. Flat nozzle with a taper of 35 °± 5 °, equipped with an automatic test cycle spray solenoid valve. Sample size: 300300x300mm (length x width x height)

6. Single nozzle flow rate=15 ± 1 liters/minute

7. Test water pressure=100 ± 5 bar

8. Device with heater and high-pressure water pump:

■ Insulated stainless steel tank, capacity 100L, including: 9KVA immersion heater, water solenoid valve, and

Upper and lower limit water level sensors

■ Water temperature sensor

Test temperature: 80 ° C ± 5 ° C

■ Recirculation pump that controls uniform water temperature

■ Piston pump, with a capacity of 21L/min and a working pressure of 150bar, equipped with a pressure reducer

■ Pressure gauge diameter 150mm - F.S. 160bar

High pressure pipes can be quickly connected

9. The distribution panel box consists of the following components:

■ Thermal magnetic circuit breaker

Programmer and thermometer

■ The microprocessor displays test cycles and alarms

■ Cold and hot cycle selector

■ Signal warning light

■ Start test button

■ Emergency stop button

■ Power supply voltage 400 ± 10% -50 Hz -3P+G+N-13kw

■ Water pipe connection 1/2 "gas, 2 bar

■ Drainage joint 1 "gas

Optional accessories

1. Turbine flowmeter for water/steam, with a range of 0.5 to 20L/min -350bar and digital display; Instantaneous water flow and calibration report released by the manufacturer.

2. A device for measuring water spray impact force, according to IEC 60529 IPX9 test level standard Figure 10, consists of the following parts: a weighing sensor with a capacity of 600 grams, a stainless steel impact plate 2x30mm, a stainless steel cover plate, a linear cyclic bearing device with a stroke of 50 mm and a stopper, and a connecting rod for moving the impact plate from the outside of the test chamber

3. The data logger "Almemo" model "2590A" has an input terminal and a connector model "ZA9105FS1" that can be connected to an upper weighing sensor.