Composition: Active constituent substances containing isoparaffins and hazardous substances.

Special note:

The spraying of release agent should be uniform and appropriate. If using a material pressure feeding container, it is recommended to use a pressure of 0.3-0.5 bar.

The correct dosage should be adjusted and tested according to the situation of each production line. The use of materials can be reduced by 1/10 of traditional release agents. When using release agents, the temperature range should be controlled between+20 ℃ and+200 ℃. After storage at a temperature below 15 ℃, quality testing should be carried out, and finally heated to 40 ℃ and stirred evenly.

After the transitional storage of mold components that require surface beautification, the surface of the components should be cleaned before surface treatment.

Important statement:

The information contained in this manual is based on our existing knowledge and good credit. It is only indicative information and not binding, especially regarding the infringement and bias of third-party rights during the use of the product. Our company guarantees that the products sold are in accordance with the sales specifications.

Only necessary preliminary testing can determine whether a product is suitable for a specific purpose, and this information cannot replace preliminary testing to determine whether a product is suitable.